Reply With QuoteI mounted mine off a couple of clamp on aerial brackets, had to place it slightly off centre though due to the HF mount, it's a 21" so you'll have a bit more of a problem. I'd try and avoid drilling the bar if at all possible.
Martyn
Master
SupporterHi guy
I have a question on mounting a 24 inch light bar.
Where it would normally mount on my ARB bar I have my 2 way arial so I was thinking of just using a clamp to mount it on the bar the problem is if centred it is actually right where the tongues are welded on.
So my question is do you think it would be a bad idea do drill a hole through the top bar so that I can mount the light bar brackets?
Cheers in advance.
Dan
AT REST
I mounted mine off a couple of clamp on aerial brackets, had to place it slightly off centre though due to the HF mount, it's a 21" so you'll have a bit more of a problem. I'd try and avoid drilling the bar if at all possible.
Martyn
1998 Defender
2008 Madigan
2010 Cape York
2012 Beadell, Bombs and other Blasts
2014 Centreing the Simpson
VKS-737 mob 7669
Master
SupporterCheers bushie
My mounts are on the sides not on a sled like yours.
Maybe I should have looked a bit harder before I bought it.
AT REST
Can you undersling it ?
Martyn
1998 Defender
2008 Madigan
2010 Cape York
2012 Beadell, Bombs and other Blasts
2014 Centreing the Simpson
VKS-737 mob 7669
Master
SupporterNo mate I have the spotties in the way.
Ill have another brain storm in the morning.
Admin
got clearer pic of your bullbar you can post up
Our Land Rover does not leak oil! it just marks its territory.......
Master
Check out my picture in this post:
LED Light Bar Group Buy!
I ran a piece of 30x30 rhs between the mounts with a notch cut out to 'sleeve the UHF aerial mounts. Then a bolt at one end, and the UHF aerial bolt at the other and you have mounting at any point between the aerial tabs.
Cheers
Rob
Master
SupporterThat's the ticket thanks Rob.
Dan
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks