Page 2 of 7 FirstFirst 1234 ... LastLast
Results 11 to 20 of 61

Thread: Word for water thrown up behind trucks

  1. #11
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,886
    Total Downloaded
    0
    Quote Originally Posted by Tins View Post
    There has often been a question of liability when giving a "safe to overtake" signal, and some drivers can be malicious enough to signal thus when it is definitely NOT.
    While it's illegal to prevent overtaking, it is not incumbent on a driver to facilitate it.

    Proceed with caution.
    Exactly,don't just take the signal as being all is OK.It might not be.Been there.

    Also it used to be one blink for the indicator,or/and a wave pass,many vehicles these days have the silly three blinks as a minimum,which can be confusing.

    Although with some of the Jap vehicles,this can be permanently and easily programmed out to one blink,which is thoughtfull.

  2. #12
    Join Date
    Apr 2012
    Location
    Whyalla, SA
    Posts
    7,545
    Total Downloaded
    0
    Quote Originally Posted by austastar View Post
    Hi,
    Jammed tight in moving traffic over the West Gate Bridge beside a stock trailer, I copped a spray of pig urine from the top deck.
    Not sure if I class that as ****ed on or ****ed off.
    Cheers
    Only a major problem if your window or sunroof was open Word for water thrown up behind trucks

    I always close all outside inputs when coming upon a stock carrier.

    I did once have a chicken get free of its surroundings and bounce off the bonnet - that was an odd one.

  3. #13
    Join Date
    Apr 2012
    Location
    Whyalla, SA
    Posts
    7,545
    Total Downloaded
    0
    Quote Originally Posted by Tins View Post
    There has often been a question of liability when giving a "safe to overtake" signal, and some drivers can be malicious enough to signal thus when it is definitely NOT.
    While it's illegal to prevent overtaking, it is not incumbent on a driver to facilitate it.

    Proceed with caution.
    I never trust them! I’ll use it as a guide to “take a cautious look” but never blindly just go.

    Usually sitting back a bit gives a clearer view especially if there’s a curve ahead, enabling forward assessment and potential passing.

    And when I do pass, it’s certainly not at posted speed - I’m out, pass and back in before hopping of the loud pedal.

  4. #14
    Join Date
    Dec 2007
    Location
    Back down the hill.
    Posts
    29,769
    Total Downloaded
    0
    As John said, old school was always a single blink, but some younger blokes (or blokettes) confuse the issue with more than one.
    Caution, some drivers use the left blinker to indicate clear to pass. I can see the logic, but in Queensland, NT and WA it was always the right. I use either signal as "I know you're there and will facilitate your overtaking manoeuvre". I always rely on my own judgment, the other driver doesn't know the power, acceleration or weight of my vehicle.
    When being approached from behind, by a faster vehicle, I use a single right blink to indicate "come past", while simultaneously moving as far left as possible, to give the other driver the best view possible. This also conveys the message that I am aware and cooperative.
    I also will give a single left blink, to indicate that it's not safe to pass.
    Usually drivers who don't understand the highway aldis language will pick it up, after three or four oncoming vehicles, or maybe that's the patience threshold.
    If you don't like trucks, stop buying stuff.
    http://www.aulro.com/afvb/signaturepics/sigpic20865_1.gif

  5. #15
    Join Date
    Sep 2010
    Location
    The Hills.
    Posts
    19,170
    Total Downloaded
    152.79 MB
    Quote Originally Posted by Tombie View Post
    I never trust them! I’ll use it as a guide to “take a cautious look” but never blindly just go.

    Usually sitting back a bit gives a clearer view especially if there’s a curve ahead, enabling forward assessment and potential passing.

    And when I do pass, it’s certainly not at posted speed - I’m out, pass and back in before hopping of the loud pedal.
    Less time spent on the wrong side of the road the better, IMO.
    ​JayTee

    Nullus Anxietus

    Cancer is gender blind.

    2000 D2 TD5 Auto: Tins
    1994 D1 300TDi Manual: Dave
    1980 SIII Petrol Tray: Doris
    OKApotamus #74
    Nanocom, D2 TD5 only.

  6. #16
    Join Date
    Sep 2010
    Location
    The Hills.
    Posts
    19,170
    Total Downloaded
    152.79 MB
    Quote Originally Posted by V8Ian View Post
    As John said, old school was always a single blink, but some younger blokes (or blokettes) confuse the issue with more than one.
    Caution, some drivers use the left blinker to indicate clear to pass. I can see the logic, but in Queensland, NT and WA it was always the right. I use either signal as "I know you're there and will facilitate your overtaking manoeuvre". I always rely on my own judgment, the other driver doesn't know the power, acceleration or weight of my vehicle.
    When being approached from behind, by a faster vehicle, I use a single right blink to indicate "come past", while simultaneously moving as far left as possible, to give the other driver the best view possible. This also conveys the message that I am aware and cooperative.
    I also will give a single left blink, to indicate that it's not safe to pass.
    Usually drivers who don't understand the highway aldis language will pick it up, after three or four oncoming vehicles, or maybe that's the patience threshold.
    Often seen the "left blink" used to indicate a hazard, like s cyclist, to following drivers, but pretty suer that's truckie language the ordinary motorist doesn't understand.

    Travelling up here in the OKA brought it all back. I was mostly happy at around 95, 100. Most trucks will do a k or so more than that on their limiter. Same as you, left blink and move over, hi beam flash once they were past and clear. Cooperation and courtesy cost nothing.
    ​JayTee

    Nullus Anxietus

    Cancer is gender blind.

    2000 D2 TD5 Auto: Tins
    1994 D1 300TDi Manual: Dave
    1980 SIII Petrol Tray: Doris
    OKApotamus #74
    Nanocom, D2 TD5 only.

  7. #17
    Join Date
    Mar 2010
    Location
    Queensland
    Posts
    4,125
    Total Downloaded
    12.97 MB
    Quote Originally Posted by Tombie View Post
    I never trust them! I’ll use it as a guide to “take a cautious look” but never blindly just go.

    Usually sitting back a bit gives a clearer view especially if there’s a curve ahead, enabling forward assessment and potential passing.

    And when I do pass, it’s certainly not at posted speed - I’m out, pass and back in before hopping of the loud pedal.
    Hello All,

    I am 100 percent with Tombie. If travelling with a passenger I also train them to report on what they can see from their perspective from the other side of the vehicles ahead.

    Most of the time there is no choice to press harder on the loud pedal because it seems the latest trend is that every arsehole despite previously going 80 kph in a 100 kph zone speeds up for an overtaking lane! Once the obstacle is past I either apply the brakes or the 'resume' button on the cruise control is pressed.

    Kind regards
    Lionel

  8. #18
    Join Date
    Mar 2010
    Location
    Queensland
    Posts
    4,125
    Total Downloaded
    12.97 MB
    Quote Originally Posted by V8Ian View Post
    As John said, old school was always a single blink, but some younger blokes (or blokettes) confuse the issue with more than one.
    Caution, some drivers use the left blinker to indicate clear to pass. I can see the logic, but in Queensland, NT and WA it was always the right. I use either signal as "I know you're there and will facilitate your overtaking manoeuvre". I always rely on my own judgment, the other driver doesn't know the power, acceleration or weight of my vehicle.
    When being approached from behind, by a faster vehicle, I use a single right blink to indicate "come past", while simultaneously moving as far left as possible, to give the other driver the best view possible. This also conveys the message that I am aware and cooperative.
    I also will give a single left blink, to indicate that it's not safe to pass.
    Usually drivers who don't understand the highway aldis language will pick it up, after three or four oncoming vehicles, or maybe that's the patience threshold.
    Hello Ian,

    Just confirming the protocol for when something like a B-Double has overtaken another vehicle. Is it a single flash on high beam to let them know they have clearance for the trailer back in the lane?

    Against my father's advice, I found myself driving the Hume Highway between Goulburn and Wagga Wagga one night. Supposedly the semi's were said to have ruled the highway during the night time. Where even the highway patrol do not venture out. I managed to tuck in behind a semi most of the way there and with everyone - except me - being on two-way radios, I had the fastest and smoothest run to Wagga Wagga. I felt safe in the process too. I kept to a distance so that I could see the truck's mirrors. I am pretty sure that word went out over the air waves for other semi drivers to watch out for the truck's shadow ... me driving a hire car.

    Kind regards

  9. #19
    Join Date
    Sep 2010
    Location
    The Hills.
    Posts
    19,170
    Total Downloaded
    152.79 MB
    Quote Originally Posted by Lionelgee View Post
    Hello Ian,

    Just confirming the protocol for when something like a B-Double has overtaken another vehicle. Is it a single flash on high beam to let them know they have clearance for the trailer back in the lane?
    Bit of a personal preference, Lionel. I used to do either one longish one or two short. But usually the overtaking truck will give an acknowledgement with his blinker that he's seen your flash. But some won't.

    Quote Originally Posted by Lionelgee View Post
    Against my father's advice, I found myself driving the Hume Highway between Goulburn and Wagga Wagga one night. Supposedly the semi's were said to have ruled the highway during the night time. Where even the highway patrol do not venture out. I managed to tuck in behind a semi most of the way there and with everyone - except me - being on two-way radios, I had the fastest and smoothest run to Wagga Wagga. I felt safe in the process too. I kept to a distance so that I could see the truck's mirrors. I am pretty sure that word went out over the air waves for other semi drivers to watch out for the truck's shadow ... me driving a hire car.

    Kind regards
    Little lost, were you?

    Nothing wrong with following a truck as long as you are courteous with your lights. Having someone constantly in the mirrors can be trying.

    One warning: moons ago I was a passenger in a car on the old Hume. The canvas tarped semi (shows just how many moons) in front lost his spare wheel from under the trailer. By the time the car's driver saw it he'd hit it. At 60 MPH it destroyed the entire front end of the HK Holden. Slipstreaming can have consequences....
    ​JayTee

    Nullus Anxietus

    Cancer is gender blind.

    2000 D2 TD5 Auto: Tins
    1994 D1 300TDi Manual: Dave
    1980 SIII Petrol Tray: Doris
    OKApotamus #74
    Nanocom, D2 TD5 only.

  10. #20
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,886
    Total Downloaded
    0
    Quote Originally Posted by Tins View Post

    Travelling up here in the OKA brought it all back. I was mostly happy at around 95, 100. Most trucks will do a k or so more than that on their limiter. Same as you, left blink and move over, hi beam flash once they were past and clear. Cooperation and courtesy cost nothing.
    A K or so over?

    I regularly do the run from here to Arrawarra,just North of Coffs,and back,very often at night.All dual lanes.

    Sitting on an actual,by the GPS of 105Km/hr,B Doubles often slowly creep past.Down hills,they fly past.

    Sitting on an actual of 110Km/hr,which is the limit for most of the trip,i go past them.

Page 2 of 7 FirstFirst 1234 ... LastLast

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!