Thread: D1 Baby Capsule Anchor Points.

All passenger cars from 198x onwards were/are required to have three anchor points for child restraints.

Dunno where on a Discovery. If the roof liner has been replaced they might have been covered over and not poked out again. Had that once, lovely clean liner ended up looking like a pincushion.

Cheers
Simon

The Disco1 has three mounting points. All above the back door. I'll go and measure the distance from the centre mount to the outer mounts and you can stab a hole in your roof lining.

400mm between the middle mount and each outer mount.

Originally Posted by Utemad

The Disco1 has three mounting points. All above the back door. I'll go and measure the distance from the centre mount to the outer mounts and you can stab a hole in your roof lining.

400mm between the middle mount and each outer mount.

There are 2 of the buttons that hold the headlining up and i thought maybe that they need to be removed to access them, RAVE doesnt mention them at all.

My hoodlining was replaced before I bought the car and it had three black push in clips where the restraints go. I've since taken them all out and the hoodlining is still up there

Originally Posted by Utemad

My hoodlining was replaced before I bought the car and it had three black push in clips where the restraints go. I've since taken them all out and the hoodlining is still up there

Ok then thats where they are, thankyou - hopefully they are a standardised thread size so i can use the spare bolt i have.

??????????

Yep they are a standard thread just pullout and thread in(no pun intended)Cheers Brett

Originally Posted by rovercare

??????????

I'd rather push my unfinished rangie ute than drive a.............people mover.


Luckily i found a spare new bolt and bracket in the wifes car so its all done, its a tight squeeze getting 2 capsules and 1 booster seat in a D1. Think i better go get my plumbing fixed !