Don't feel bad!!
It's been sitting next to this for 4 months now:
https://www.aulro.com/afvb/
:censored::censored::censored:
Printable View
Don't feel bad!!
It's been sitting next to this for 4 months now:
https://www.aulro.com/afvb/
:censored::censored::censored:
Here we go ... bloody high isn't it.
https://www.aulro.com/afvb/images/im...014/04/984.jpg
I found it's specs online and was staggered to find it was just over 2.8 meters high :eek:
https://www.aulro.com/afvb/images/im...014/04/985.jpg
We have the shed I work on stuff in, I try not to park anything in this, it's only 12 x 7 meters so will fill quickly.... The door opening is only about 2meters :eek:
https://www.aulro.com/afvb/images/im...014/04/986.jpg
Then there's the carport.... it's about 10 x 7 meters .... height, at the back it's less than two meters, that is a tiny pop top under it that isn't mine. It's low... very low for a caravan.... hmmm....
https://www.aulro.com/afvb/images/im...014/04/987.jpg
We have this 10 x 6 meter shed ( diffucult access, 2meter height on the rafters and full of cars) ... and the ugly brown POS that leaks like a sieve and was built out of already stuffed 2nd hand materials 25years ago....
https://www.aulro.com/afvb/images/im...014/04/988.jpg
it only has bikes, mowers and maybe a car in it if I'm feeling brave. I can't even walk under it's rafters without ducking (so there just under 6foot high), it's rotten, it stinks................. Hmm, but it's the only location where I can easily back big trailers and caravans too.... hhhhhmmmmmmmmmmmmmmmmmmm.....
Out with the angle grinder :evil: :evil: :evil
https://www.aulro.com/afvb/images/im...014/04/989.jpg
I chopped the front wall out, removed the roof and the side wall........ But left two walls on otherwise there would be no cross bracing for the frame......... then chopped the uprights through. I found it was actually sitting on the bloody ground. I started by digging holes around it that were deep enough to get the trolley jack under with.... then lifting it evenly all around... Then I moved onto a bottle jack, sitting ontop of a stack of tires. I thought I had it nice and high at this point, so grabbed a 3meter long piece of lumber to check the rafter height (I was thinking 3meters would be enough to jack the caravan to check wheel bearings etc...). Yep, I was right, so close I only had about another meter to go :eek: :eek: :eek:
https://www.aulro.com/afvb/images/im...014/04/990.jpg
It's taken a while, but I'm finally there now. It only took a stack of four car wheels with a bottle jack lifted to it's highest sitting on top of the stacked wheels. I just need to weld the extended uprights back to the footings.... I don't trust the old footings (given the shed was literally sitting on the ground). So I have dug secondary ones beside the existing footings, and will weld a secondary set of footing off the uprights, over too these holes and cement them in as well.
https://www.aulro.com/afvb/images/im...014/04/991.jpg
Then all I'll need to do is chase up some decent roofing iron and finish re-cladding it... You don't have to be insane, but it helps :clown: :banana:
seeya,
Shane L.
I'm sure it's nice but you need to host your photos somewhere else for us to see them.
OK pics of shed
This is the front showing all the bushes and trees I cleared. There is also a curved garden bed in there to make access dificult
https://www.aulro.com/afvb/images/im...014/04/979.jpg
Inside showing how the sorting to get the garage back is progressing. That's the brothers X19 parked in there.
https://www.aulro.com/afvb/images/im...014/04/980.jpg
Scored the second shed so now I have to pick it up.
Will finish clearing the bushes and tree debris out the front so I can dig out the raised bed. Should be adding 6 meters to the front.
Since I started this thread.... an update:D
We are extending again to put in a spraybooth, a area for the finger folder, and the guillotine.
Pics shortly;)
Mrs hh:angel:
The shed in Kalgoorlie. Originally three "bays" but I've enclosed one of them to make workshop / toolstore.
Has plenty of height - I can work on the camper trailer with the roof fully up inside the shed. :D
https://www.aulro.com/afvb/images/im...014/04/968.jpg
https://www.aulro.com/afvb/images/im...014/04/969.jpg
https://www.aulro.com/afvb/images/im...014/04/970.jpg