Reply With QuoteProClip mounting platform for vehicles*|*Brodit
for those with issues drilling into the dash to fit a handset bracket check these out. I personally have one and they are extremely simple to fit or remove without leaving a mark.
Cheers
Julian
Fossicker
Hello Pete and others
Completed the installation toady, unit under drivers seat and control/speaker on the dash. I went with a MobileOne 4.5dBi antenna and it is working perfectly. I just need to learn the unit and the CB protocol
Your advice and insights were invaluable I will post some photos when I work out how to include them the same way you (Pete) did in your initial message
Regards
Master
ProClip mounting platform for vehicles*|*Brodit
for those with issues drilling into the dash to fit a handset bracket check these out. I personally have one and they are extremely simple to fit or remove without leaving a mark.
Cheers
Julian
Member
Hi, wondering how you may have got the front cover off the drivers seat to access the underneath, is there a special way to pull that sucker off, other than throwing it to the tip when i get it off ??
Master
Normally if you put the seat at full height and fully forward it will give you enough access to work with in the space... I think many (most?) people have mounted under the passenger seat using the existing bracket with a few tweaks. Scott has a good write up here: Scott's Discovery 4Originally Posted by Landis3
David
Everything is easy when someone else is doing it
MY14 SDV6 SE Corris Grey
Compomotive 18s : D697s : Traxide DBS : LLAMS : ARB compressor : IC-455
Rhino Platform : GOE compressor, Tx & front bash plates, deluxe sliders
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks