Thread: Service Indicator

This is from a land Rover Manual on setting the service indicator.

Reset Procedure
There are two ways of resetting the service interval indicator. T4 can be connected to the
vehicle and diagnostic routine performed or a manual reset procedure can performed
using the trip rest button on the instrument cluster.
Manual Reset Procedure
• Press and hold the trip reset button.
• Turn the ignition switch on to the ignition position II.
• If the SII function is set in the CCF the information display will flash 'SERVICE'
for 5 seconds and then display 'SERVICE' constantly. If the SII function is not set
in the CFF the information display will show the normal odometer and trip
information.
• The software will check if remaining distance service is enabled (threshold
reached). If the remaining distance service is not enabled the procedure will
continue from step K.
• If the trip reset button is released within 10 seconds of entering the reset mode,
the information display will show 'OIL'.
• If the trip reset button is not released after 10 seconds, the display will show the
next service type and distance/days to next service and the instrument cluster will
exit the manual reset procedure.
• If the oil service value reset is not required, press the trip reset button within 10
seconds of releasing it in step E and hold for less than 5 seconds and proceed to
step H. This will by-pass the oil service reset procedure.
• If the oil service value is to be reset, press the trip reset button within 10 seconds
of releasing it and hold for more than 5 seconds. The information display will
show 'RESET' for 5 seconds and then reset the oil service value.
• If reset is not possible, the information display will show 'CANNOT RESET' for
5 seconds.
• The information display will show 'INSPECT'.
• If the inspection service value reset is not required, press the trip reset button
within 10 seconds of releasing it in step G and hold for less than 5 seconds and
proceed to step K. This will by-pass the inspection service reset procedure.
• If the trip reset button is not pressed after 10 seconds, the display will show the
next service type and distance/days to next service and the instrument cluster will
exit the manual reset procedure.
• If the inspection service value is to be reset, press the trip reset button within 10
seconds of releasing it and hold for more than 5 seconds. The information display
will show 'RESET' for 5 seconds and then reset the inspection service value.
• If reset is not possible, the information display will show 'CANNOT RESET' for
5 seconds.
• The software will check if date service is enabled (threshold reached). If the date
service is not enabled the procedure will continue from step O.
• The information display will show 'DATE'.
• If the date service value reset is not required, press the trip reset button within 10
seconds of releasing it in step I and hold for less than 5 seconds and proceed to
step O. This will by-pass the date service reset procedure.
• If the trip reset button is not pressed after 10 seconds, the display will show the
next service type and distance/days to next service and the instrument cluster will
exit the manual reset procedure.
• If the date service value is to be reset, press the trip reset button within 10 seconds
of releasing it and hold for more than 5 seconds. The information display will
show 'RESET' for 5 seconds and then reset the date service value.
• The information display will show 'END'.
• If the trip reset button is pressed within 10 seconds and pressed for less than 5
seconds the procedure will return to step E


IvanR