Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: HDC, Transmission and Suspension Failure Indicator

  1. 24th October 2011, 09:46 PM #21
    Trevlynn
    Trevlynn is offline Member
    Join Date
    Oct 2011
    Location
    Eltham VIC
    Posts
    4
    Total Downloaded
    0
    my 2008 TDV6 HSE did the same thing a few months ago. Warning lights, messages and went into limp home mode. When i came to a stop I lost all drive. Got out, locked it and waited afew minutes and problem was gone. Rang dealer next day and they indicated the usual brake switch issue as the most likely cause. When it went in and they plugged it into the computer it turned out to be the fuel pump which was replaced. It appears problem is fixed. Luckily it was still under warranty.
    Reply With Quote Reply With Quote
  2. 25th October 2011, 08:49 AM #22
    NavyDiver's Avatar
    NavyDiver
    NavyDiver is offline Very Very Lucky! Gold Subscriber
    Join Date
    Feb 2010
    Location
    Melbourne
    Posts
    10,247
    Total Downloaded
    0

    Brake Controller is interesting idea but not the issue

    Found the suspension error a few times over 1000km traveled over the last week with no trailer on. I had the brake control in. Un-plugged controler and 300km later had seen no more errors. Coming back saw the error occur again and have seen it a few more times with the controler unplugged so I can scratch that theory.
    Ritters suggested the air compresor was working just not as effecently as the specs. The error if it goes to Red and with 30mph speed limit warning resolves it self back to yellow. New compressor might be needed.
    Reply With Quote Reply With Quote
  3. 3rd November 2011, 05:13 PM #23
    NavyDiver's Avatar
    NavyDiver
    NavyDiver is offline Very Very Lucky! Gold Subscriber
    Join Date
    Feb 2010
    Location
    Melbourne
    Posts
    10,247
    Total Downloaded
    0

    Suspension control unit- reflash and Air compresor

    Re flashing the Suspension Control unit on my 2005 D3 SE worked a treat. Should have been done a long time ago. I wonder why it isn't done? If the coding is updated as much as it was from 2005 to 2010 as I have just discovered then I would have thought this is a must for all D3 and after a while D4 owners as well.

    How can we tell if new codes are developed by LD for our trucks?
    How many Control units do we have? Height, E.C.U., 4WD options at a guess.

    All my issues are now fixed. Going to get the above list answered next time it is in the shop in another 10k km. I wonder if I had had the re-flash before the new compressor was fited if the new one would have been needed. It was pumping a little slowly so I am happy to have it new now.
    Reply With Quote Reply With Quote
Page 3 of 3 FirstFirst 123
« ATF Group Buy? | Hawkeye In Southern Tablelands »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!