Results 1 to 9 of 9

Thread: I think I have EPB fault

  1. #1
    Join Date
    Jan 2010
    Location
    Newman WA
    Posts
    889
    Total Downloaded
    0

    I think I have EPB fault

    When I park the D3 with the EPB in the on position,and then turn the ignition key off and pull it out , the RED park brake warning stays on .
    The Park brake works perfectly normally during normal driving .Seems to do all the right things when asked , no noise ,holds well and releases well .
    Recently changed my rear discs ,which eleiminated my vibration issue , RHR was warped , set the EPB as per Bodsys brake manual , 60ft/lb and then back off 8 clicks .
    Im wondering if I havent left on ,some diagnostic/repair mode , as I did the stabdard 3 brake press, hold on the third , and hold EPB off/down for 3 seconds , then Key off and out and pull FL8.
    Didnt notice this before I did the rear Disc change , so somethingI did or didnt do has bought this fault on .

  2. #2
    Join Date
    Aug 2008
    Location
    Sunshinecoast QLD
    Posts
    485
    Total Downloaded
    0
    EPB light does stay on for a minute or so, when turned off.
    Or do you mean stays on permenantly., that would be a problem.


    Cheers Ken

  3. #3
    Join Date
    Jan 1970
    Location
    Bangor, NSW
    Posts
    1,508
    Total Downloaded
    0
    Quote Originally Posted by 400HPONGAS View Post
    When I park the D3 with the EPB in the on position,and then turn the ignition key off and pull it out , the RED park brake warning stays on .
    This is working as designed -the light goes out after all the onboard computers have shut down.

    I had the EPB "squealer" in my D3 - it was following a couple of river crossings and then hitting dusty roads. I suspect muck gummed it up.

  4. #4
    Join Date
    Jan 2010
    Location
    Newman WA
    Posts
    889
    Total Downloaded
    0
    Spot on Jonesy , thats because its SWMBO 's car! I only drive it once a month and have never noticed it before. Sure enough exactly 3 mins after the ignition off key out , the red Parkbrake light goes off .

  5. #5
    Join Date
    Jan 1970
    Location
    Canberra
    Posts
    18,616
    Total Downloaded
    0

    Manual Release EPB - RRS

    I have looked through the Handbook for my 07 RRS to see how to get to the handbrake emergency release cable but cannot find it anywhere. Page 177 talks about using the EBD but not about using the cable.

    So where might I find the instructions in the RRS handbook?

    Note the centre console in the RRS is different to the D3 so the D3 instructions may or may not apply.

    Thanks

    Garry
    REMLR 243

    2007 Range Rover Sport TDV6
    1977 FC 101
    1976 Jaguar XJ12C
    1973 Haflinger AP700
    1971 Jaguar V12 E-Type Series 3 Roadster
    1957 Series 1 88"
    1957 Series 1 88" Station Wagon

  6. #6
    Join Date
    Jan 1970
    Location
    Melbourne
    Posts
    2,622
    Total Downloaded
    0
    Garry,
    Here goes!
    Remove gear shifter, pull knob straight up, do not twist, do not hit oneself in chin!
    Lift rear console lid up & you will see the start of the the entire centre console trim! Now this entire piece comes off from the front of the cubby box to under neath the HEVAC. Place appropriate lifting tool, hard plastic boning tool is what I use, under the rear of the console section lift up to loosen the clips that hold it down, now place hands under the silver or wood trims (depending on which you have) & lift firmly up, be careful & try not to separate the silver or wood trims from the main section, once it starts it will then lift off relatively easily.
    Once this unit comes away, you can unplug the unit & you will see the release cable, silver cable in a loop with a white clamp around it.

    HTH.

    Cheers

  7. #7
    Join Date
    Jan 1970
    Location
    Canberra
    Posts
    18,616
    Total Downloaded
    0
    Hmmm - Ok - I think I follow, so I take this procedure is not in the handbook. I think I will just print your post and put it in the handbook in case I need it.

    Thanks

    Garry
    REMLR 243

    2007 Range Rover Sport TDV6
    1977 FC 101
    1976 Jaguar XJ12C
    1973 Haflinger AP700
    1971 Jaguar V12 E-Type Series 3 Roadster
    1957 Series 1 88"
    1957 Series 1 88" Station Wagon

  8. #8
    Join Date
    Jan 1970
    Location
    Melbourne
    Posts
    2,622
    Total Downloaded
    0
    No, Not in the handbook strangely enough

  9. #9
    Join Date
    Oct 2009
    Location
    St George Dragons Territory, NSW
    Posts
    745
    Total Downloaded
    0
    Quote Originally Posted by sniegy View Post
    Garry,
    Here goes!
    Remove gear shifter, pull knob straight up, do not twist, do not hit oneself in chin!
    Lift rear console lid up & you will see the start of the the entire centre console trim! Now this entire piece comes off from the front of the cubby box to under neath the HEVAC. Place appropriate lifting tool, hard plastic boning tool is what I use, under the rear of the console section lift up to loosen the clips that hold it down, now place hands under the silver or wood trims (depending on which you have) & lift firmly up, be careful & try not to separate the silver or wood trims from the main section, once it starts it will then lift off relatively easily.
    Once this unit comes away, you can unplug the unit & you will see the release cable, silver cable in a loop with a white clamp around it.

    HTH.

    Cheers

    Much easier in the D3,

    George

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!