If I buy a used one it is probably on its way out. If I buy a new one it is expensive. Anyway here is where I am at I will try to fix it and if I can not then I have to buy a one.
I got the glove box out using a casing from a pen and a small screw and pushed the pins out a very easy job. removing the small trims were scarier because I might break them taking them out.
OP talked about placing a metal pin does anyone have an idea does it go across both tabs at the glove box? and how is the handle installed is it just pushed into those tabs?
I glued it together for now and placed a paper clip to hold it in place. Maybe I will put a fabric or fiberglass that in place to give it more strength. It is so flimsy on that side. It is really better off as a RHD drive design because the sturdier side will be where it is being pulled if the driver sit on the RH side.
Member
Posting Permissions
Reply With Quote
Bookmarks