Results 1 to 9 of 9

Thread: Aaaarrrrrgggghhh

  1. 15th March 2012, 07:49 AM #1
    simoncs
    simoncs is offline Master Subscriber
    Join Date
    Sep 2010
    Location
    sydney
    Posts
    133
    Total Downloaded
    0

    Aaaarrrrrgggghhh

    So get into garage last night and car is in full height mode. We have to lower the car to get in. Thinking the worst I checked the roof, and sure enough there are scratches all over. My mother is out from the Uk and used the car last. Seems as though she forgot to lower the.car as she came in.

    Anyone know some where in Sydney to get this repaired? They are too deep to buff out.

    Also, maybe a stupid question but, since a 4wd excursion, there is a very slight vibration from I think the passenger side front. Very dull rumbling noise too. I have had a look but nothing obvious. Any suggestions before I take it too a garage.


    Sent from my MB860 using Tapatalk
    Reply With Quote Reply With Quote
  2. 15th March 2012, 08:53 AM #2
    peterall
    peterall is offline Fossicker Supporter
    Join Date
    Aug 2008
    Location
    Adelaide SA
    Posts
    75
    Total Downloaded
    0
    Simon, the vibration is most likely to be mud build up on the inside rim of that wheel. Quite common from sticky mud baths.
    Reply With Quote Reply With Quote
  3. 15th March 2012, 10:07 AM #3
    simoncs
    simoncs is offline Master Subscriber
    Join Date
    Sep 2010
    Location
    sydney
    Posts
    133
    Total Downloaded
    0
    Quote Originally Posted by peterall View Post
    Simon, the vibration is most likely to be mud build up on the inside rim of that wheel. Quite common from sticky mud baths.
    I guess it could be - it was a very wet/muddy trip- I have pressure washed the underside though and i can't see anything - could it be that i have just got to remove the wheel to have a look? I guess it won't hurt...
    Reply With Quote Reply With Quote
  4. 15th March 2012, 11:13 AM #4
    Graeme
    Graeme is online now Swaggie Vendor
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    Vibration of a rear wheel can often be thought to be coming from a front wheel and I've found that rear wheels are more prone to picking-up mud.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa
    Reply With Quote Reply With Quote
  5. 15th March 2012, 12:08 PM #5
    Celtoid
    Celtoid is offline ChatterBox
    Join Date
    May 2010
    Location
    Brisbane, QLD, Australia
    Posts
    2,252
    Total Downloaded
    0
    Doesn't take much to affect the balance either.

    The last time I was on the beach my car didn't look that dirty....it was almost undriveable above 60kph.

    A quick wash at Harvey Bay and it was all good.

    Cheers,

    Kev.
    Reply With Quote Reply With Quote
  6. 15th March 2012, 12:16 PM #6
    Geedublya
    Geedublya is offline Wizard Silver Subscriber
    Join Date
    Dec 2009
    Location
    Ranelagh, Tasmania
    Posts
    1,543
    Total Downloaded
    0
    Sydney Smash Repairs, Panel Beater, Smash Repairers || Jack Hillermans Artarmon

    Supposed to be one of the best around.
    Fuji white RRS L494 AB Gone
    2023 Ford Ranga
    Reply With Quote Reply With Quote
  7. 26th March 2012, 10:39 AM #7
    simoncs
    simoncs is offline Master Subscriber
    Join Date
    Sep 2010
    Location
    sydney
    Posts
    133
    Total Downloaded
    0
    hmmm, so i pulled the wheels off and can't see anything. The weights for balancing are still on the wheels as well.

    I did notice though that i am missing the front recovery point cover. I took it off for our sand driving course and maybe i didn't fit it back again properly.

    could the noise/vibration just be wind related? - has anyone driven without this cover on and noticed a slight vibration?

    I will try to get another on as have seen them on uk ebay sites (i guess this will be cheapest)

    it has to get it's pink slip in the next 2 weeks so is due to go to the garage anyway...
    Reply With Quote Reply With Quote
  8. 26th March 2012, 10:43 AM #8
    go-disco4
    go-disco4 is offline Fossicker
    Join Date
    Jul 2010
    Location
    Australia
    Posts
    90
    Total Downloaded
    0

    recovery point cover

    my cover is off all the time

    no noise or vibration from it

    gd-4
    Reply With Quote Reply With Quote
  9. 26th March 2012, 12:15 PM #9
    simoncs
    simoncs is offline Master Subscriber
    Join Date
    Sep 2010
    Location
    sydney
    Posts
    133
    Total Downloaded
    0
    Quote Originally Posted by go-disco4 View Post
    my cover is off all the time

    no noise or vibration from it

    gd-4
    thanks for that - will just have to see what the garage com up with then - just hope it's something simple/cheap
    Reply With Quote Reply With Quote
« How do I bleed fuel filter 2007 TDV6? | I laughed a little »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!