Thread: D4 Bullbar

Opposite Lock and they look almost the same. They also have provision for the forward facing cameras/sensors

Cheers
Merv

Anybody else had an Opposite Lock Bar fitted to their D4? I have and I'm disappointed to say the least. There is a massive gap between the lights and the bar of on average about 20mm although as the bar is not level this changes from side to side. Going back next Friday to let them have another go but have been told that the gap is to stop damage to the flairs and lights over corrugations.
Olid4,
I believe that I saw somewhere else on the forum that somebody had had an ARB fitted to a HSE. Its there somewhere!

Both the OL and ARB bars will have gaps under the headlights due to the design of the D4 bumper and grill. The OEM plastic bumper curves up to meet the headlights whereas the aftermarket bars are a straight line. OL have tried to improve the finish by installing rubber fillers under the headlights. Not ideal l guess but better than a big gap.

The official word from ARB is that their bar will not fit a HSE. Newcastle ARB refused to even try and referred me to Mannell Motors in Sydney. However, there are at least 2 members on this forum who have the ARB bar fitted. I'm looking at the OL bar myself to ensure ADR / insurance compliance.

Discojools, ask about the rubber inserts for under the headlights. The Newcastle OL branch was not aware of them until l mentioned it. They checked with head office and they should be supplied with the bar.

Regards Trif.

Is anyone able to load a photo? Also, any costs for comparison would be handy as well.

Cheers

Oli

Yeah have the rubber inserts below the lights but still around 20mm gap. Looks c**p! Will try and post some pics if I can remember how! Actually how do I attach pics to my post?

As far as costs are concerned OL bar was $1595 plus 400 for colour coding and 350 for fitting. Ends up bout the same as ARB who told me there was a 3 month wait which I have since found out wasn't true! In the end there wasn't time to get OL to paint so I had it done by my guy for $250. Unfortunately he will have to do it again (he's agreed no problem) as for some reason etching primer didn't work properly. All in all a bit of a disaster on all fronts!

I will get a pic with the wife gets home. My OL bar is a perfect fit. Did have to have the flares trimmed a touch more so that they did not touch over rough ground.....this is not an OL fault. 2100 all up fitted and colour coded....I had them do all the other work at the same time, so deal overall was excellent.

I think they have taken too much off my flares..discotwinturbo, sounds like you got a good deal. Look forward to some pics.

These pics have been supplied to me by Opposite Lock..if you pm me your email address I will send you a copy of all the pics they sent me. I think OL have slightly differing prices depending on the area of operation. Prices quoted to me were $1499.00 + $400.00 colour coding =$400.00 fitting. ( a couple of the pics I have wouldn't load)