Page 6 of 12 FirstFirst ... 45678 ... LastLast
Results 51 to 60 of 113

Thread: Transmission fault/HDC fault

  1. #51
    Join Date
    Jan 1970
    Location
    Bangor, NSW
    Posts
    1,508
    Total Downloaded
    0
    Quote Originally Posted by bvs View Post
    Bought the switch off ebay from Landybits for $45.
    Or $28 if you can walk into a Land Rover dealership parts department.

  2. #52
    Join Date
    Nov 2007
    Location
    Melbourne, Vic
    Posts
    547
    Total Downloaded
    0
    Replaced my brake control switch today so hopefully will be error free for a while to confirm this. I used the guide provided by bbyer a few posts back and it is spot on.
    Took longer to pull the old switch apart than replace it.
    There was some black powder in the assembly and you could see where the internal contacts were rubbing. Obviously the old switch was still working but I guess it was possible it could fault ocassionally. Time will tell.

  3. #53
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,033
    Total Downloaded
    0
    Perhaps clean-up the old switch using contact cleaner to swap back when the new one starts to go.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

  4. #54
    Join Date
    Jan 2010
    Location
    Edmonton Alberta Canada
    Posts
    743
    Total Downloaded
    0

    Ford part number perhaps an alternative?

    Cleaning the contacts has merit, particularily if somewhat distant from a LR dealer. An alternative to consider that just may be viable is to use the Ford part number for the switch which I presume would be available from or thru a Ford Australia dealer. The 2008 and 2009 Ford Fusions used the same switch as do our 3's, and I guess now the 4 as well.

    There are two Ford Motorcraft part numbers for the switch as follows:

    SW-6572 and 7E5Z-13480-A
    Attached Images Attached Images

  5. #55
    Join Date
    Oct 2008
    Posts
    96
    Total Downloaded
    0
    Quote Originally Posted by bbyer View Post
    Cleaning the contacts has merit, particularily if somewhat distant from a LR dealer. An alternative to consider that just may be viable is to use the Ford part number for the switch which I presume would be available from or thru a Ford Australia dealer. The 2008 and 2009 Ford Fusions used the same switch as do our 3's, and I guess now the 4 as well.

    There are two Ford Motorcraft part numbers for the switch as follows:

    SW-6572 and 7E5Z-13480-A
    I recently bought a spare from my local dealer and when I took it out of the Land Rover box and had a look at it, it clearly had FoMoCo stamped on the back of it.

    Lou...

  6. #56
    Join Date
    Nov 2007
    Location
    Melbourne, Vic
    Posts
    547
    Total Downloaded
    0
    Got the faults again this morning with the new brake switch. Actually it repeated a couple of times before it cleared. New switch didn't fix the problem. If it actually occurs more frequently with a new switch probably means it is switch related. Will need to monitor for the next month or so.

  7. #57
    mcmanusd Guest
    Multiple faults are also caused by a dirty MAP sensor -
    see DISCO3.CO.UK - View topic - Engine System Fault
    Symptoms will be loss of power, multiple fault messages (HDC, Park Brake, Transmission, Limited gears), lowered suspension etc.
    May occur once or several times in short succession and then may be OK for a few days of weeks but will gradually become more frequent.
    Easy to clean as described in the link above so worth doing to eliminate it as a cause of problems.

  8. #58
    SBD4's Avatar
    SBD4 is offline A Keeper of the TGO Gold Subscriber
    Join Date
    Dec 2011
    Location
    Bundeena
    Posts
    2,809
    Total Downloaded
    0

    2 stroke oil in diesel 200:1?

    Just read the linked post in the disco3 forum. A couple of the guys talk about the benefits of adding 2So to their tanks when they fill up. what do you think? Any down sides to doing this?

    ...
    This morning I checked the MAP sensor as a matter of routine servicing and again it was sqeeky clean. So yes 2sO works and helps the friendly D3 owner to prevent unloading unnecessary repair $,£, ZAR etc at the stealers.

    Our vehicle had the dreaded HPFP/Injector collapse in Botswana last year at 130'000km and came back to Pretoria on a low-bed truck. I advised the previous owner at that time to start using 2sO and despite various trips to Botswana, Zim, Zambia etc with its notoriously bad (paraffin spiking!!) diesel, there has never been an issue again with lubricity related problems. An added benefit of using 2sO is the fantastic internal cleaning properties of 2sO (removal of carbon deposits)!!!

    I am using the Sasol 2sO, as it is Jaso-FC graded and available at every Sasol station in the country. If I do longer overland trips I carry a supply of those bottles (200ml) with me. On the D3 I use 200ml per tank and on the 300Tdi 500ml per tank.

    On the 300Tdi there is a marked increase in performance with a corresponding drop in smoke when running at a 1:200 ratio.
    ...
    Cheers,

    Sean

    “Only two things are infinite, the universe and human stupidity, and I'm not sure about the former.” - Albert Einstein

  9. #59
    Join Date
    Nov 2007
    Location
    Melbourne, Vic
    Posts
    547
    Total Downloaded
    0
    More faults this evening that took a couple of goes to bypass. Seems problem is worse with a new brake switch. Does this mean the plug or some sort of feedback to the connector is a possible cause of the fault? Also seemed on a couple of times that the car didn't want to crank over. Stopped and started a few times after a 10 min drive and all good again.

    or.... battery....

  10. #60
    Join Date
    Aug 2010
    Location
    Sydney
    Posts
    1,874
    Total Downloaded
    0
    The guy that is leading my trip swears by it!
    http://www.disco3.co.uk/forum/topic79420.html
    I have started using it, I have noticed less smoke when I plant my foot.
    Only done 165k using the 2 stroke mixed with the diesel at 400ml per tank.
    I use Castrol Activ 2 which is mineral based not synthetic.
    2014 SDV6 HSE - LLAMS, Tuff Ant Tree Sliders, Tuff Ant 18" rims, Nitto Ridge Grappler tyres 265/65 R18, Custom Lipo4 battery, Custom Drawer storage system https://www.box.com/s/jem0ilac3cner2mexq64

Page 6 of 12 FirstFirst ... 45678 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!