Page 3 of 12 FirstFirst 12345 ... LastLast
Results 21 to 30 of 113

Thread: Transmission fault/HDC fault

  1. #21
    Join Date
    Aug 2010
    Location
    Sydney
    Posts
    1,874
    Total Downloaded
    0
    Heh Rob are you just going to buy one locally?
    I'm after one too.
    2014 SDV6 HSE - LLAMS, Tuff Ant Tree Sliders, Tuff Ant 18" rims, Nitto Ridge Grappler tyres 265/65 R18, Custom Lipo4 battery, Custom Drawer storage system https://www.box.com/s/jem0ilac3cner2mexq64

  2. #22
    Join Date
    May 2007
    Location
    Byford, WA
    Posts
    1,317
    Total Downloaded
    0
    Hi there,
    Electric brake controller, I had no end of problems until I wired it into the trailer connection in the back left hand side of the vehicle, never had a problem since. Also shorted out the tranny module once when I washed the engine bay out, that was a steep learning curve.......... Thank goodness for Faultmate MSV2 I say.

  3. #23
    Join Date
    Mar 2010
    Location
    Peregian beach
    Posts
    211
    Total Downloaded
    0
    I have had the gearbox fault, emergency park brake and suspension faults come up a few times in my D4 and the culprit was a badly adjusted brake pedal switch.

    These same faults as other have said can be reproduced if you depress the brake pedal and accelerator at the same time, confusing the computer and bringing up errors.

  4. #24
    Join Date
    Jan 1970
    Location
    Bangor, NSW
    Posts
    1,508
    Total Downloaded
    0
    Quote Originally Posted by ~Rich~ View Post
    Heh Rob are you just going to buy one locally?
    I'm after one too.
    Hi Rich - yes, will ring around tomorrow.

    Let me see... 8 pounds in UK... about $20 in USA... what do you reckon they will be here? I had better have one last drink -before I sell a kidney.

    Cheers,
    Rob

  5. #25
    Join Date
    May 2011
    Location
    Orange Grove WA
    Posts
    1,274
    Total Downloaded
    0
    Quote Originally Posted by jonesy63

    Hi Rich - yes, will ring around tomorrow.

    Let me see... 8 pounds in UK... about $20 in USA... what do you reckon they will be here? I had better have one last drink -before I sell a kidney.

    Cheers,
    Rob
    With postage from the uk it comes to about 35, or from the us 40 all up.
    Brett...

  6. #26
    Join Date
    Jan 1970
    Location
    Bangor, NSW
    Posts
    1,508
    Total Downloaded
    0
    Rich - just rang my local dealer (man!) and it is about $27 and they have them in stock.

  7. #27
    Join Date
    Aug 2010
    Location
    Sydney
    Posts
    1,874
    Total Downloaded
    0
    Thx Rob, I'll contact my local mechanic then.
    2014 SDV6 HSE - LLAMS, Tuff Ant Tree Sliders, Tuff Ant 18" rims, Nitto Ridge Grappler tyres 265/65 R18, Custom Lipo4 battery, Custom Drawer storage system https://www.box.com/s/jem0ilac3cner2mexq64

  8. #28
    jacknnick Guest
    Thanks everyone for your help, especially bbyer and 400HPonGas. Bought the new replacement brake light switch on Ebay Australia from landy_bits2010 part# XKB 500110 for $35 came within two days, took about 25 seconds to fit it, all the alarms have gone away. Thanks very much.

  9. #29
    Timj is offline Wizard Silver Subscriber
    Join Date
    Feb 2008
    Location
    Brisbane,Qld.
    Posts
    1,194
    Total Downloaded
    0
    I haven't been so lucky, fitted a new switch yesterday and replaced the blown brake light that I didn't even realise was blown and today I got the errors more often than I ever have before. Previously it would pretty much fault once then be ok for a while, this time it went three times very quickly while on the Gateway motorway so I got off and headed back home and it still went another couple of times on the way home. Took the gear I had in the back out and into the Series 3 Game and off we went again, no faults in that one at least .

    Is there anything else that can cause these errors together, Transmission fault, HDC fault, Suspension fault? It is always in the same situation, hill or slight rise, put the foot down to get up it and everything dies and goes into limp mode. Pull over, turn the car off for a few seconds, start it up and off you go again until the next time.

    Thanks,

    TimJ.
    Snowy - 2010 Range Rover Vogue
    Clancy - 1978 Series III SWB Game.
    Henry - 1976 S3 Trayback Ute with 186 Holden
    Gumnut - 1953 Series I 80"
    Poverty - 1958 Series I 88"
    Barney - 1979 S3 GS ex ADF with 300tdi
    Arnie - 1975 710M Pinzgauer

  10. #30
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,030
    Total Downloaded
    0
    Quote Originally Posted by Timj View Post
    I haven't been so lucky, fitted a new switch yesterday and replaced the blown brake light that I didn't even realise was blown and today I got the errors more often than I ever have before.
    You might want to have someone follow you to be sure that your brake lights aren't coming on of their own accord due to incorrect switch adjustment. You could also try using cruise control when possible to see if it cancels itself.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa

Page 3 of 12 FirstFirst 12345 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!