Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Power feed to 12 pin plug

  1. 27th February 2016, 06:45 AM #1
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0

    Power feed to 12 pin plug

    G'day all,

    I've a 2009 D4 HSE with tow pack. I need to run a power feed to one of the pins on my 12 pin flat socket for the trailer that only provides 12v when the ignition is on. I could poke around until I find one but I'm looking to find out where others have sourced from. Ideally, it would be near the back of the disco.

    Cheers
    Caine
    Reply With Quote Reply With Quote
  2. 27th February 2016, 10:27 AM #2
    LRD414's Avatar
    LRD414
    LRD414 is offline Super Moderator Subscriber
    Join Date
    Oct 2014
    Location
    Brisbane
    Posts
    3,737
    Total Downloaded
    0
    Why not just use the 12S (white) plug? Source or make an adapter to go to your 12pin plug or splice behind the plug. It has both ignition feed (6) and constant feed (4).


    Scott
    D4 TDV6 MY14 with Llams, Tuffant Wheels, Traxide DBS, APT sliders & protection plates, Prospeed Winch Mount w/ Carbon 12K, Mitch Hitch & Drifta Drawers
    Link to my D4 Build Thread
    D3 2005 V8 Petrol
    Ex '77 RRC 2 door. Long gone but not forgotten.
    Reply With Quote Reply With Quote
  3. 27th February 2016, 10:47 AM #3
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0
    Thanks Scott.

    Yesterday I checked both the flat 12 and the round 12S and both didn't have the ignition v as described, that is, there was no difference in v if the car was off or the reds were on.

    Today, after your post, I measured again with the car started. And yes, it gave me my 12+v I need on 12S-6. So thanks.

    ** I only need a constant 12 to tell the REDARC in the camper to accept charge from the car, not the solar panels...
    Reply With Quote Reply With Quote
  4. 27th February 2016, 12:29 PM #4
    drivesafe's Avatar
    drivesafe
    drivesafe is offline OldBushie Vendor
    Join Date
    Jan 1970
    Location
    Queensland
    Posts
    7,904
    Total Downloaded
    0
    Hi Scott and if your solar is permanently fixed to your camper, you could save yourself a lot of work and simply leave the Redarc on the solar input and bypass it with the alternator supply going directly to your house battery

    This would allow your house batter to be charged from two sources at the same time, making for a faster recharge setup, and no need to run any extra wiring.

    For Land Rover Specific Dual Battery Systems and Headlight Wiring Upgrade Kits,
    Reply With Quote Reply With Quote
  5. 27th February 2016, 12:42 PM #5
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0
    G'day Tim,

    I've got the choice of both as the camper has two Andersen inputs, one that goes through the REDARC and one straight to house batteries. The fixed 300watt solar goes through the REDARC, of course. Everything comes wired and all I've had to do is get 12v to the pin. Your dual batt kit is in the car so an Andersen comes off of that.

    Only thing left for me to do is to run a feed through the plug to the front of the car for the emergency brake monitor.

    Cheers.
    Reply With Quote Reply With Quote
  6. 27th February 2016, 12:42 PM #6
    LandyAndy's Avatar
    LandyAndy
    LandyAndy is offline RoverLord Gold Subscriber
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    There are or were a couple of 12S plugs in the markets.
    http://www.aulro.com/afvb/body-exter...-hawthorn.html

    http://www.aulro.com/afvb/body-exter...-hawthorn.html

    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post
    Reply With Quote Reply With Quote
  7. 27th February 2016, 12:44 PM #7
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0
    Thanks Andrew. Luckily I don't need any parts as the car, and camper, have it all.....except for a long new wire run....cheers
    Reply With Quote Reply With Quote
  8. 27th February 2016, 12:45 PM #8
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0
    Oh, and I've just worked out its a lot easier to get to the back of the plug with the spare wheel out of the way.....ha
    Reply With Quote Reply With Quote
  9. 27th February 2016, 01:31 PM #9
    drivesafe's Avatar
    drivesafe
    drivesafe is offline OldBushie Vendor
    Join Date
    Jan 1970
    Location
    Queensland
    Posts
    7,904
    Total Downloaded
    0
    Quote Originally Posted by catch-22 View Post
    Only thing left for me to do is to run a feed through the plug to the front of the car for the emergency brake monitor.
    Hi again "Caine", are you referring to a BREAKAWAY BATTERY MONITOR?

    For Land Rover Specific Dual Battery Systems and Headlight Wiring Upgrade Kits,
    Reply With Quote Reply With Quote
  10. 27th February 2016, 03:52 PM #10
    catch-22
    catch-22 is offline Wizard
    Join Date
    Jan 2007
    Location
    here
    Posts
    1,213
    Total Downloaded
    0
    Hi Tim,

    Yeah exactly. I'll try harder next time. Ha

    Cheers
    Reply With Quote Reply With Quote
Page 1 of 2 12 LastLast
« Advice needed, aircon and engine fan problem | Driving with GOE Rods »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!