Thread: GOE height extension rods installation

Hi,

First off sorry if this ends up being a stupid question. But I feel better asking rather than causing damage to my car.

I have received my 3 way height sensor rods fro GOE and have had a read through the installation document all sounds clear to me except the following.

Does the orientation of the rod matter? For ease of helping me I have attached a photo showing what I am referring to as the front on each rod.

For the front rod does the front need to face towards the center of the car or the outside?

For the rear rod does the front need to face towards the front of the car or the rear?

Thanks for any help.

CassianIMG_6574.JPG

From memory it is only on the RRS that there is a particular orientation for I think the rear. Fit the rods so that the adjusting end is on the fixed peg on the vehicle and not the height sensor, reduces any risk of putting any undue pressure on the sensor arm when changing rod holes.