Thread: Removal of pins from connector

The yellow section locks the pin retaining tabs so remove that section first. You should then be able to slide a pin down the side of the socket that has crimped the wire, as determined from the rear, to hold a tab away from the socket to allow the socket to be withdrawn.

Edit: Those sockets probably have a barb each side rather than the plastic housing having a tab. The barbs have to be sprung in together which normally requires a special tool. I attempted to remove such sockets from a slightly different housing but bought new housings and sockets, although I am fabricating a loom rather than modifying an existing one.

What do you hope to achieve?