Thread: oil pouring from front crank

The seals have been known to work their way out.

Known fault and acknowledged by LR. I understand the fix is a newly designed seal seat that is not as finely finished to help the seal to remain in place. In many cases this end up in a big end failure after the engine is run without oil for some time. This is however different to the big end bearing failure more commonly diagnosed.
There is a new design housing that should be ordered, obviously along with a new seal.
You're very lucky indeed to not lunch the engine.

I wouldn't be driving it any futher.
It will empty the sump and destroy the engine.
Needs a flat top ride to the repairer.
Andrew

thx for that . motor is pulled down , will order new seal and crank bolt tomorrow, will give it another go , pain in the arse job , specialty getting the starter out
was heading up the coast tomorrow , best it happened here than middle of no where , cheers Pete

Some people have used bearing retainer on the (new) seal to make sure that it doesn't walk.