Thread: Aftermarket wheel nut wrench

Originally Posted by goofyr

Thanks yeah the nuts I tried are definitely damaged. I want to try another wrench before I consider replacing the damaged nuts.

That is not going to end well, you are more likely to make the situation worse. Put it down to experience, replace the nuts and get a better wrench.

Originally Posted by jimbotron

When tightening, are you using a torque wrench to get the specified/recommended torque setting?
I am trying to decide on one of those extension bars like above or a torque wrench or both!

I have both. The extension handle wrench is ideal to undo nuts but I prefer to finish the tightening up by torque wrench.
However around town I don't bother carrying the torque wrench because the wrench is good enough until you get home to check torque.

Scott

Originally Posted by Mog60

I have these and think they work well kincrome-4-piece-wheel-nut-impact-socket-set-met-1-2dr-k2180.html
Attachment 138339

X2

Originally Posted by jimbotron

When tightening, are you using a torque wrench to get the specified/recommended torque setting?

I am trying to decide on one of those extension bars like above or a torque wrench or both!

Cheers.

No I’m just using the bar.

Originally Posted by Ciaran

I had this issue a couple of years ago. The integrated metal cover to the nuts become deformed. I bought a 23mm 6-sided deep socket as well as a 600mm long handled 1/2” breaker bar from Repco to get them off.

Replaced them with new nuts sourced from LRDirect in the UK (using the proper 22mm size socket - only six sided - avoid the 12 sided sockets). Getting the nuts from the UK was considerably less expensive than sourcing locally.

I also purchased a Warren & Brown torque wrench from Blackwoods to ensure nuts were torqued properly. Have not had an issue since.

Thanks I might have to get the 23mm to get the deformed nuts off

Originally Posted by LRD414

That is not going to end well, you are more likely to make the situation worse. Put it down to experience, replace the nuts and get a better wrench.
Scott

Thanks I will do that, but I got to get the nuts off first. Hence looking for a wrench that will fit. I might just get my indy to do it as he has it for a couple of days to replace the radiator.

Cheers,
Randy

Originally Posted by goofyr

Thanks I will do that, but I got to get the nuts off first. Hence looking for a wrench that will fit. I might just get my indy to do it as he has it for a couple of days to replace the radiator.

Cheers,
Randy

If you are replacing them and have the replacements with you then hammering on the socket then hammering it off once removed, then discarding is easy enough.

I carry a long 3/4" drive ratchet, short extension, and the socket. No problems. I don't carry a $100 torque wrench in the car but if I have to change a tyre then I torque it at home when the repaired tyre goes back on.

Originally Posted by DiscoJeffster

If you are replacing them and have the replacements with you then hammering on the socket then hammering it off once removed, then discarding is easy enough.

Cool thanks I’ll keep that in mind. I don’t have replacements at the the moment.

Cheers,
Randy