What are you recommending? How many ohms? Would adding just at the ground work all signals?Quote:
Originally Posted by Tombie
Printable View
What are you recommending? How many ohms? Would adding just at the ground work all signals?Quote:
Originally Posted by Tombie
not switchable that i know of, and trailer symbol has never come on.Quote:
Originally Posted by Tombie
Maybe you need to ask the bloke who fitted it all why you don't get the trailer symbol when you hitch a trailer.Quote:
Originally Posted by Eevo
Think you will find a hidden switch somewhere.
See post #5 on the 1st page of this thread, all the info you need is there. https://www.aulro.com/afvb/l319-disc...ml#post2916698Quote:
Originally Posted by imaz
Thanks, just picked up the below from altronics.Quote:
Originally Posted by kelvo
Plan to make an adapter for 7 Large to 7 small, with this in between. 15Ohm, 10w ceramic.
https://uploads.tapatalk-cdn.com/202...84f0a610ba.jpg
I said to myself , "self.....when your trailer lights blow or burn out then is the time to put flash dancing leds onto the trailer"
so, 10 or 15yrs later , after replacing the rusted **** steel bottom of the trailer with formply , and replacing the **** tyres with almost **** ones , the lights are still perfect
Take them back...Quote:
Originally Posted by imaz
6 Ohm is what you need...
10X 50W 6ohm 6Ω Load Resistors For Hyper Flash Turn Signal Blinker LED Bulb | eBay
Wouldn’t a higher resistance just run it at less amps, cooler. altronics did have a 6ohms, 10w.Quote:
Originally Posted by Tombie
I think you will find that the low current draw from the LED lights is the the reason why the car can't detect them in the first place.Quote:
Originally Posted by imaz
The Narva ones are 8 ohm and work fine. I fitted them to my camper.
Narva Load Resistor 21W 12V 90034BL | Sparesbox