What happened to your D3/D4 today?

Quote:

---

Originally Posted by Spence

“should’ve got a traxide”

---

Hi Spence and if it is what you need!
Just out of curiosity, what did it cost and how much does it weigh?

Quote:

---

Originally Posted by drivesafe

Hi Spence and if it is what you need!
Just out of curiosity, what did it cost and how much does it weigh?

---

With all the goodies inside it weighs about 12 kg. Cost me $900.

Attachment 166733Attachment 166734 Whipped this up today. Goes all the way under the false floor.

Quote:

---

Originally Posted by josh.huber

Hey mate, do you have goe suspension rods by any chance. They may have just put the height sensor back in the wrong hole. Both arms would have been done with the car raised so the bush clamp shouldn't cause that. Don't forget we can raise these cars about 100mm without issue. If that was the issue. Put the car in offroad height and see if the low corner raises easily.

The wheel alignment would have been done and adjusted on the 4 post with the car sitting level so the bushes should be happy.

---

Cheers for the reply. Standard rods.
I thought that if the top arms were left to hang without the LCA on, the sensors would be damaged.
PCB LR did end up having a chat to me & mentioned it could be bent fittings.
D4 up on stands, wheels off & found RHS bracket that's welded to the chassis that holds sensor was pushed substantially down & back.
Removed sensor & hammered back to where it looked normal again.
Vehicle sat ok (to 9mm height diff between sides) and went back to mechanic.
When i explained there was a witness damage mark on the bracket, but not on the top arm, he admitted using a bar on it to jimmy the strut to line with the LCA.
Such fun.

Attachment 166753 Tidy up the tailgate a bit today. Fitted a black and white badge, and took off the factory plastics.

Quote:

---

Originally Posted by Bendys

Cheers for the reply. Standard rods.
I thought that if the top arms were left to hang without the LCA on, the sensors would be damaged.
PCB LR did end up having a chat to me & mentioned it could be bent fittings.
D4 up on stands, wheels off & found RHS bracket that's welded to the chassis that holds sensor was pushed substantially down & back.
Removed sensor & hammered back to where it looked normal again.
Vehicle sat ok (to 9mm height diff between sides) and went back to mechanic.
When i explained there was a witness damage mark on the bracket, but not on the top arm, he admitted using a bar on it to jimmy the strut to line with the LCA.
Such fun.

---

Least you got it sorted quickly and without cost.. He won't do that again hopefully.

Attachment 166757Attachment 166758Attachment 166759Attachment 166760
Custom trimmed steering wheel.

Quote:

---

Originally Posted by Spence

Attachment 166757Attachment 166758Attachment 166759Attachment 166760
Custom trimmed steering wheel.

---

Nice. What’s one of those worth?

Quote:

---

Originally Posted by John_D4

Nice. What’s one of those worth?

---

About 400 fun tokens.

Quote:

---

Originally Posted by Spence

About 400 fun tokens.

---

From where? Interested for my D3.