Thread: rock slider/steps

of coarse gussets will be welded in , once I figure hole spacings

never had sills off, not sure whether they go back on after fitting

Originally Posted by stuarth44

never had sills off, not sure whether they go back on after fitting

No.

Your plan wont work as the chassis is inboard of the sills, rock sliders bolt to the threaded inserts hidden by the plastic sill covers.

Body mount profile is also not 90 degrees.

There’s a section at approximately 45deg

Not sure if you can see it in the end of image below.

Originally Posted by Tombie

Body mount profile is also not 90 degrees.

There’s a section at approximately 45deg

Not sure if you can see it in the end of image below.

thanks a mill, ok I need a bit of shaping, will do that in my plate wheels as my folder will not form 6mm that lenngth

Originally Posted by loanrangie

Your plan wont work as the chassis is inboard of the sills, rock sliders bolt to the threaded inserts hidden by the plastic sill covers.

yes sussed it out thanks

Originally Posted by stuarth44

thanks a mill, ok I need a bit of shaping, will do that in my plate wheels as my folder will not form 6mm that lenngth

yes ok your image the slider is upside down, sent pm

Originally Posted by stuarth44

yes ok your image the slider is upside down, sent pm

Ok. Will get better image this arvo