Page 2 of 5 FirstFirst 1234 ... LastLast
Results 11 to 20 of 49

Thread: The cults is done it again

  1. #11
    Join Date
    Sep 2014
    Location
    Baldivis WA
    Posts
    2,293
    Total Downloaded
    0
    Quote Originally Posted by wbowner View Post
    Many thanks all

    Yep I do know how to check oil and warm it up beforehand. I had been monitoring it regularly as was dropping a bit , I am towing a van.

    It sometimes takes longer than 10 min before I get a reading
    I had heard there was a bit of trick to doing sooner but was not sure how

    I have used the cut bottle technique previously. I had just thought I found a better and more accurate way to do it. Good theory just bad implementation on my part
    M
    Hmm I've towed a camper van all over the place and never ever has the engine used a skerric (technical term-slightly less than a smidge) of oil between oil changes that is noticeable on the level indicator. Me suspects something else is going on....

  2. #12
    Join Date
    Aug 2013
    Location
    ACT
    Posts
    664
    Total Downloaded
    0
    Yep
    I normally don’t use much oil if any and have a feeling something wrong, I have it booked in for a service later in the month, the earliest I could get it done as I am on the road traveling.

    Richard

  3. #13
    Join Date
    Nov 2015
    Location
    Black Rock
    Posts
    1,228
    Total Downloaded
    0
    Don't be concerned if the 3.0L TDV6 uses about 250ml in about 10k kms.
    2013 D4 expedition equipped
    1966 Army workshop trailer
    (previously SII 2.25 swb, SIII 2.25 swb & lwb, P38 Vogue, 1993 LSE 3.9V8 then HS2.8)

  4. #14
    350RRC's Avatar
    350RRC is offline ForumSage Silver Subscriber
    Join Date
    Mar 2008
    Location
    Bellarine Peninsula, Brackistan
    Posts
    5,501
    Total Downloaded
    0
    Quote Originally Posted by wbowner View Post
    Yep
    I normally don’t use much oil if any and have a feeling something wrong, I have it booked in for a service later in the month, the earliest I could get it done as I am on the road traveling.

    Richard
    Diesel dilution? Doesn't cost much to get a sample analysed.

    DL

  5. #15
    josh.huber Guest
    Quote Originally Posted by scarry View Post
    A dipstick just seems so much easier......and it's accurate.

    WTF were they thinking.
    Yeah we get it, you bought a different vehicle!

    The vehicle you bought actually needs a dipstick. Why do I say that, they drank oil, I had one and I lived through 3 engines.

    Sorry if I come off rude, but this is the D4 Forum, not the LC justification forum, we bought them, still have them, have to live with them.

  6. #16
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,886
    Total Downloaded
    0
    Quote Originally Posted by josh.huber View Post
    Yeah we get it, you bought a different vehicle!

    The vehicle you bought actually needs a dipstick. Why do I say that, they drank oil, I had one and I lived through 3 engines.

    Sorry if I come off rude, but this is the D4 Forum, not the LC justification forum, we bought them, still have them, have to live with them.
    You are definitely on the completely wrong track here,i had a D4 for 10yrs with a dipstick.

    And every other vehicle i have ever had has had a dipstick for the engine oil,easy to check when doing other regular checks,or whenever.

    Never had an issue,wait until you have to replace the electronic level device,if its not a dumb idea with no advantage over a dipstick,why go away from one.

    The later Ingenium engines have dipsticks.

    Go figure.

    Maybe think before you type......

    And no,the D4,and the new vehicle both have never used any oil.None.

  7. #17
    JDNSW's Avatar
    JDNSW is online now RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,511
    Total Downloaded
    0
    Worth a thought - If I remember correctly, the early postwar Rover cars had a dashboard switch which allowed the fuel gauge to read oil level. And my father's 1923 Reo had a mechanical float operated gauge on the side of the engine to show the oil level. Then there is the ford T system - two petcocks on the sump (which is also the flywheel housing) - if oil does not come out the lower one when opened, oil is low - close it, open the top one and fill until oil runs out, then close. But almost all motor vehicles ever built use dipsticks for engine oil level, so there does seem to be a bit of experience to support the idea.
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  8. #18
    Join Date
    Apr 2016
    Location
    Melbourne
    Posts
    4,517
    Total Downloaded
    0
    Quote Originally Posted by JDNSW View Post
    Worth a thought - If I remember correctly, the early postwar Rover cars had a dashboard switch which allowed the fuel gauge to read oil level. ...
    Yeah, this is probably the ideal method.

    dipsticks themselves can have various issues, and remote displays can have issues too.
    My '79 Lancia HPE had a gauge that did same(could have been fuel gauge too).
    IIRC I think it used a vacuum/pressure setup to operate. It seemed fairly accurate from what I could tell.

    My dads 307HDI Peugeot has a dash readout(about 5 small circles) when ignition is on, and stays lit after startup.

    LR should have at least added a remote fluid level monitor for the dipstickless later model(D2 and later) auto transmissions.
    It's nice to have one in the D1, and sorely missed in the D2.
    Arthur.

    All these discos are giving me a heart attack!

    '99 D1 300Tdi Auto ( now sold :( )
    '03 D2 Td5 Auto
    '03 D2a Td5 Auto

  9. #19
    Join Date
    Oct 2011
    Location
    Fremantle WA
    Posts
    3,838
    Total Downloaded
    0
    Quote Originally Posted by AK83 View Post
    Yeah, this is probably the ideal method.

    dipsticks themselves can have various issues, and remote displays can have issues too.
    My '79 Lancia HPE had a gauge that did same(could have been fuel gauge too).
    IIRC I think it used a vacuum/pressure setup to operate. It seemed fairly accurate from what I could tell.

    My dads 307HDI Peugeot has a dash readout(about 5 small circles) when ignition is on, and stays lit after startup.

    LR should have at least added a remote fluid level monitor for the dipstickless later model(D2 and later) auto transmissions.
    It's nice to have one in the D1, and sorely missed in the D2.

    You can add a D1 auto trans dipstick to a D2. I have one fitted to my D2/TD5 RRC
    D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
    RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
    SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies

  10. #20
    Join Date
    Mar 2016
    Location
    Perth
    Posts
    4,335
    Total Downloaded
    0
    Quote Originally Posted by scarry View Post
    You are definitely on the completely wrong track here,i had a D4 for 10yrs with a dipstick.

    And every other vehicle i have ever had has had a dipstick for the engine oil,easy to check when doing other regular checks,or whenever.

    Never had an issue,wait until you have to replace the electronic level device,if its not a dumb idea with no advantage over a dipstick,why go away from one.

    The later Ingenium engines have dipsticks.

    Go figure.

    Maybe think before you type......

    And no,the D4,and the new vehicle both have never used any oil.None.
    2010 TDV6 3.0L Discovery 4 HSE
    2007 Audi RS4 (B7)

Page 2 of 5 FirstFirst 1234 ... LastLast

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!