Yep
I normally don’t use much oil if any and have a feeling something wrong, I have it booked in for a service later in the month, the earliest I could get it done as I am on the road traveling.
Richard
 Master
					
					
						Subscriber
					
					
						Master
					
					
						SubscriberYep
I normally don’t use much oil if any and have a feeling something wrong, I have it booked in for a service later in the month, the earliest I could get it done as I am on the road traveling.
Richard
Don't be concerned if the 3.0L TDV6 uses about 250ml in about 10k kms.
2013 D4 expedition equipped
1966 Army workshop trailer
(previously SII 2.25 swb, SIII 2.25 swb & lwb, P38 Vogue, 1993 LSE 3.9V8 then HS2.8)
Yeah we get it, you bought a different vehicle!
The vehicle you bought actually needs a dipstick. Why do I say that, they drank oil, I had one and I lived through 3 engines.
Sorry if I come off rude, but this is the D4 Forum, not the LC justification forum, we bought them, still have them, have to live with them.
You are definitely on the completely wrong track here,i had a D4 for 10yrs with a dipstick.
And every other vehicle i have ever had has had a dipstick for the engine oil,easy to check when doing other regular checks,or whenever.
Never had an issue,wait until you have to replace the electronic level device,if its not a dumb idea with no advantage over a dipstick,why go away from one.
The later Ingenium engines have dipsticks.
Go figure.
Maybe think before you type......
And no,the D4,and the new vehicle both have never used any oil.None.
Worth a thought - If I remember correctly, the early postwar Rover cars had a dashboard switch which allowed the fuel gauge to read oil level. And my father's 1923 Reo had a mechanical float operated gauge on the side of the engine to show the oil level. Then there is the ford T system - two petcocks on the sump (which is also the flywheel housing) - if oil does not come out the lower one when opened, oil is low - close it, open the top one and fill until oil runs out, then close. But almost all motor vehicles ever built use dipsticks for engine oil level, so there does seem to be a bit of experience to support the idea.
John
JDNSW
1986 110 County 3.9 diesel
1970 2a 109 2.25 petrol
 TopicToaster
					
					
						Supporter
					
					
						TopicToaster
					
					
						SupporterYeah, this is probably the ideal method.
dipsticks themselves can have various issues, and remote displays can have issues too.
My '79 Lancia HPE had a gauge that did same(could have been fuel gauge too).
IIRC I think it used a vacuum/pressure setup to operate. It seemed fairly accurate from what I could tell.
My dads 307HDI Peugeot has a dash readout(about 5 small circles) when ignition is on, and stays lit after startup.
LR should have at least added a remote fluid level monitor for the dipstickless later model(D2 and later) auto transmissions.
It's nice to have one in the D1, and sorely missed in the D2.
Arthur.
All these discos are giving me a heart attack!
'99 D1 300Tdi Auto ( now sold :( )
'03 D2 Td5 Auto
'03 D2a Td5 Auto
D4 MY16 TDV6 - Cambo towing magic, Traxide Batteries, X Lifter, GAP ID Tool, Snorkel, Mitch Hitch, Clearview Mirrors, F&R Dashcams, CB
RRC MY95 LSE Vogue Softdash "Bessie" with MY99 TD5 and 4HP24 transplants
SADLY SOLD MY04 D2a TD5 auto and MY10 D4 2.7 both with lots of goodies
 TopicToaster
					
					
						Subscriber
					
					
						TopicToaster
					
					
						Subscriber| Search AULRO.com ONLY! | Search All the Web! | 
|---|
|  |  | 
Bookmarks