Results 1 to 2 of 2

Thread: LH or RH thread

  1. 8th January 2008, 01:38 PM #1
    RichardK
    RichardK is offline ChatterBox Silver Subscriber
    Join Date
    Jan 1970
    Location
    Western Australia
    Posts
    2,955
    Total Downloaded
    0

    LH or RH thread

    Does anyone know whether the thread on the thermo fan to the main drive pulley is LH or RH?
    RichardK

    Series IV Matrix Offroad Camper following our Discovery 3 with E Diff, BAS Remap, Mitch Hitch, Uniden UHF, Codan NGT HF, Masten TPMS, Proquip Compressor Guard, ARB Winch Bar, Milemarker Hydraulic Winch, 4x4 Intelligence Rear Wheel Carrier, VMS GPS with Rear Camera,
    Reply With Quote Reply With Quote
  2. 8th January 2008, 01:41 PM #2
    Slunnie's Avatar
    Slunnie
    Slunnie is offline Swaggie Gold Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    14,127
    Total Downloaded
    99.87 MB
    If its a reverse thread it will have a nick in it all the way around, much same as all of your gas bbq fittings do. It is also setup on the engine to be self tightening when acting on the fan, so turn it the other way.
    Cheers
    Slunnie


    ~ Discovery II Td5 ~ Discovery 3dr V8 ~ Series IIa 6cyl ute ~ Series II V8 ute ~
    Reply With Quote Reply With Quote
« Installing UHF antenna | Getting a good deal on a 2007 TDV6 SE »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!