Thread: 4.4 TDV8 oil leaks

I had a small oil leak whiilst under warranty - ended up being a cracked (plastic) engine cover. Took Solitare two goes to get it wright. If it wasn't covered by warranty I would not have bothered. They had to remove the fuel line (which means replacing them).

Peter Brown might be slow at times but is very competent, the Dealer however is just in........

Originally Posted by mattjtaylor2809

I seem to have the same issue but with my MY14 RRS TDV8 HSE....small drops of oil & increasingly noticing burnt oil smell.

Had the car serviced, mentioned this & the dealer (PCB in Adelaide) said that he did see considerable amount of oil on one side of the engine but that he's not seen this before in a TDV8. He mentioned something about replacing something in the V & quoted roughly $2,500 for the job BUT...said he would look into this further.

It's been x2 weeks & I've rung them x3 times & he;s still not returned my calls....I'm worried I'm doing more damage & with school holidays coming up, would like to go for a drive!!

Hopefully it's O' ring but I'm not sure whether this post was in relation to L494 engines or older?

Cheers
Matt

PS - I also found this video online, is this the same?

YouTube

It was a good move to have the inlet manifold replaced as it would have become worse and eventually caused restricted performance due to loss of pressure. I'm hoping that mine has the only later version of the manifolds that were fitted to the first L405 4.4SDV8.

I have a 2106 SDV8 that is showing a smear of oil on the rear front bash plate. Can't find out where the leak is coming from at present, have taken the valley cover off but the plumbing gets in the way. Will pull sump guard off (Bash Plate) and try and determine if the leak is local or coming down from the top. Hoping not a turbo leak although I think I would smell burning oil if it was. Wondering if Graeme's post is current for the later 4.4 ?