Thread: Discovery 5 iidtool not working- anyone else ?

Had an issue with mine on the L322 . Emailed the guys from Gap with my problem and had a reply in 24 hrs

I have an IIDTool BT which works fine on my D5. But it will only read and clear fault codes at present, and while it seems to read the CCF there's no way of displaying it. What are the errors you are getting? Did you manage to activate the tool?

Ron

No, didn't get as far as activating it. Worked fine on the D4.

The unit itself won't read the CANBUS. Just loops around looking for it.

Spoke to GAP, they think its prob an issue with a change in the SD4 electrical architecture

Originally Posted by IndusD4

I have an IIDTool BT which works fine on my D5. But it will only read and clear fault codes at present, and while it seems to read the CCF there's no way of displaying it. What are the errors you are getting? Did you manage to activate the tool?

Ron

Hey Ron, does it at least allow you to change/recalibrate the height?

I'd have to check, haven't used that as off road 2 is high enough for where I take it.

Originally Posted by IndusD4

I'd have to check, haven't used that as off road 2 is high enough for where I take it.

I had a play with the 3 suspension height settings, setting 1 changed to +25 but the car didn’t move up nor down. Setting 2 changed to +29 (highest it would go at the front) but also no change in ride height when selecting that setting.

Ron