Thread: 2a GS Refurb ARN 178-334

The hardtop is sold, someone is going to try and fit it to a Defender.

The hood bows are installed, the parts that fit round the doors are ready to be painted.
Removing the multiple layers of olive drab took a while.

I need to replace the vent seals as they have decomposed, removed the vents for painting and removed about 6 layers of paint from them !
Next I'll get a hand to remove the windscreen, once I've painted the top of the bulkhead I'll fit the windscreen I painted a while ago.

The seal between bulkhead & windscreen needs to be replaced, I was surprised at the cost.....luckily I had one 'in stock'.
Seal - bulkhead to windscreen - Paddock Spares

Colin

Picture attached showing the layers of paint and the decomposed seal.
The chap I got the Land Rover from was ex Army and he claimed the vehicles were re-painted whenever top brass visited, looking at the layers it's been re-painted many times.
Interestingly my Series III FFR seems to be in it's original paint.

Somehow I need to strip the multiple layers of paint on the top edge of the bulkhead & re-paint. Probably a fair bit of masking which is something the Army didn't do ! I'd better buy some more paint stripper......

While looking at the rear crossmember I found the NATO trailer socket has rusted badly so when I tidy up the back end I need to find a replacement !

Looking forward to getting this one and the FFR finished so I can get back to the Dormobile.


Colin

I've made some seat covers and about to fit them to new bases with new foam.

Decided today to start it up as it just sits idle in the back shed.
Firstly no electrics when the key was turned, cleaned battery terminals and power returned.
Tipped some fuel into the inlet, manually operated the fuel pump a few times (although it didn't seem to fill the line and reduce the lever travel), turned the key and nothing ! I'd removed the instrument panel trying to work out why the charging light isn't working and had displaced a wire, re-fitted and....it still wouldn't start. Tried a few times, more petrol down the inlet fired briefly but wouldn't run.
Decided it was probably the fuel pump again, I've had stale petrol stick the valves previously.
Took the top off the carby and there was no fuel in the float chamber. Filled the float chamber and it started but......the temperature gauge & fuel gauge weren't working !

Turned it off and fiddled with the fuses and the gauges came good. Once the engine was running the fuel pump seemed to wake up.

At one point the charging light came on when the key was turned but it's back to no light again ! Looks like I need to strip and clean every electrical connection at some point in the near future.


Colin