Page 1 of 2 12 LastLast
Results 1 to 10 of 12

Thread: Bit of a list

  1. #1
    Join Date
    May 2007
    Location
    hobart
    Posts
    161
    Total Downloaded
    0

    Bit of a list

    My Rangie has recently developed a lean to the left on a couple of occasions after driving for an hour or so. It has been faulting the eas on a reasonably regular basis and though I have changed the whole box,- valve block, pump and driver this hasn't helped.I clear the fault with a buddy box (USB TYPE)and on long runs the faulting is persistent enough to make me use the mars system and pull the plug on the pump. At least that way I dont have to stop every half to 1 hour and correct the fault.
    The lean to the left is not always the way it faults but it's happened 3 or 4 times in the last few weeks.
    Could the regular faulting be caused by sensor(s) out of range.
    Any thoughts please.
    John

  2. #2
    Join Date
    Jan 1970
    Location
    back in the suburbs, near joondalup
    Posts
    3,438
    Total Downloaded
    0
    leaky airbag?

  3. #3
    Join Date
    May 2007
    Location
    hobart
    Posts
    161
    Total Downloaded
    0

    bit of a list

    It doesn't seem like a leaky airbag as with the manual recovery operating and the taps off and compressor disconnected I can drive 200 -300 k's with no noticeable loss of air pressure. When it decides to lean it happens in 100 metres of so.

  4. #4
    Join Date
    Aug 2007
    Location
    Brisbane
    Posts
    3,234
    Total Downloaded
    0
    Quote Originally Posted by parasnoop67 View Post
    My Rangie has recently developed a lean to the left on a couple of occasions after driving for an hour or so. It has been faulting the eas on a reasonably regular basis and though I have changed the whole box,- valve block, pump and driver this hasn't helped.I clear the fault with a buddy box (USB TYPE)and on long runs the faulting is persistent enough to make me use the mars system and pull the plug on the pump. At least that way I dont have to stop every half to 1 hour and correct the fault.
    The lean to the left is not always the way it faults but it's happened 3 or 4 times in the last few weeks.
    Could the regular faulting be caused by sensor(s) out of range.
    Any thoughts please
    .
    John
    Damned nuisance!! It's possible the sensor is out of range and the buddybox is simply restoring the status quo (=default values) in the ECU until the sensor starts playing up again...are FL and RL measurements equally down in relation to FR & RR? or is one LH spring dragging the other down?

    The buddy box is no doubt OK for soft fault rectification but Storey wilson s/w loaded onto a PDA enables you to read what the faults are and
    recalibrate.

    One relatively quick method of seeing if it is a sensor is to swap the FL sensor with the FR. If this manouevre hasn't been done previously they will be tracking on previously unused parts of the rheostat ...just like new ones. If it doesn't fix things, swap the rears as well...

    The SW s/w is a must have and I'd recommend you get it ASAP
    cheers
    A.

  5. #5
    Join Date
    May 2007
    Location
    hobart
    Posts
    161
    Total Downloaded
    0

    Bit of a list

    Thanks for that Hoges, I will swap the sensors and see how that goes.

    John

  6. #6
    Join Date
    Nov 2006
    Location
    narellan, sydney
    Posts
    1,131
    Total Downloaded
    0
    Is it always at the same height it leaks or does it so it on several height settings? I have seen some cracked bags leak only at certain heights as when they are lower they roll over themselves and seal up the crack/hole.

    Andy

  7. #7
    Join Date
    May 2007
    Location
    hobart
    Posts
    161
    Total Downloaded
    0

    bit of a list

    It faults mostly on smooth roads at 90-110k's. The bags were all new 3 years ago and have done about 70000k's. Sometimes I'll drive 100k's before it faults but sometimes only 10k's between buddy box fixes.The lean to the left has only happened 3 times but it's a recent change in behavior. I was wondering if a sensor may be out of range and different to the one on the other side.

  8. #8
    Join Date
    May 2008
    Location
    Canberra
    Posts
    1,834
    Total Downloaded
    0
    Hi John

    What codes does the EAS Buddy show you when you plug it in to your PC?

    <putting on the sales guy hat> The main advantage the EAS Buddy has over the EAS Kicker Lite is that it stores the faults it clears for later reading on a PC/Mac. It stores the faults in a text file that can be read off the EAS Buddy just like a USB flash drive <end sales talk>

    If one of your sensors is out of range due to a mechanical fault like the arm pulling out of the rubber mount (such as happened to me yesterday out near the Black Spur) then it will stay in fault until you fix the mechanical problem and then reset the fault with the Buddy.

    Cheers, Paul.
    My toys, projects and write-ups at PaulP38a.com

  9. #9
    Join Date
    May 2007
    Location
    hobart
    Posts
    161
    Total Downloaded
    0

    Bit of a list

    Thanks Paul and all others. It's going in to Justin Coopers tomorrow to have a couple of steering bits renewed so I'll get him to look at/ change sides with the sensors. Or tell me if they are stuffed.
    The buddy box messages vary from fr valve stuck closed, cant raise fr, fl valve stuck closed etc.
    John

  10. #10
    Join Date
    May 2008
    Location
    Canberra
    Posts
    1,834
    Total Downloaded
    0
    if the faults only occur at 90-100Kph, then your EAS will be at Highway height... maybe the range on one the potentiometers at that height is worn out? Just a thought.

    The types of faults it is returning seem to indicate sticky solenoids rather than a HS problem.

    You mentioned that you have replaced the EAS driver block... do you still have the old one to swap over as a test?

    Cheers, Paul.
    My toys, projects and write-ups at PaulP38a.com

Page 1 of 2 12 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!