Results 1 to 3 of 3

Thread: PLEASE HELP - EAS manual overrides.

  1. 4th November 2012, 06:58 PM #1
    benji's Avatar
    benji
    benji is offline Wizard Supporter
    Join Date
    Jan 2012
    Location
    Bendigo
    Posts
    1,643
    Total Downloaded
    0

    PLEASE HELP - EAS manual overrides.

    My cousin in stuck in Beechport in his D2 with an airbag that won't inflate.

    Does anyone know if the manual override valves for the p38 will work on a D2? They're a 6mm pipe to the airbag like the p38s, but they're a screw in connector.

    I believe there was a guy on this forum a few years ago who sold manual override valves that suited the p38 and D2.

    If they are the same, it may be a very late night drive.
    Reply With Quote Reply With Quote
  2. 4th November 2012, 07:07 PM #2
    Blknight.aus's Avatar
    Blknight.aus
    Blknight.aus is offline RoverLord Vendor
    Join Date
    Aug 2006
    Location
    Melbourn(ish)
    Posts
    26,499
    Total Downloaded
    0
    just head yourself to a good truck shop or pirtek they will be able to sell you adaptors that you can use to break into then adapt the lines to other compressed air sources...

    worst case go male nitto-ballvalve-6mm line press fit adaptor.

    cut the lines near the top of the airbag fit the adaptors open the ball valve and use a compressor to pump up the bags, close the ball valve and disconnect.
    Dave

    "In a Landrover the other vehicle is your crumple zone."

    For spelling call Rogets, for mechanicing call me.

    Fozzy, 2.25D SIII Ex DCA Ute
    Tdi autoManual d1 (gave it to the Mupion)
    Archaeoptersix 1990 6x6 dual cab(This things staying)


    If you've benefited from one or more of my posts please remember, your taxes paid for my skill sets, I'm just trying to make sure you get your monies worth.
    If you think you're in front on the deal, pay it forwards.
    Reply With Quote Reply With Quote
  3. 5th November 2012, 01:14 AM #3
    PaulP38a's Avatar
    PaulP38a
    PaulP38a is offline Wizard Gold Subscriber
    Join Date
    May 2008
    Location
    Canberra
    Posts
    1,834
    Total Downloaded
    0
    Disco 2 SLS air lines are 4mm.

    Splice a Schrader Valve with 4mm adapter on to each of the 2 air lines in the SLS unit attached to the chassis rail. One on each side, the middle line is air supply to/from dryer.

    To disable SLS you remove Relay 5 in the engine bay fuse box.

    Standard height for SLS is approx 450mm measured from centre of wheel cap to bottom lip of the wheel arch.

    See the instructions for the Hard Range D2 SLS Bypass Kit at http://hardrange.com/downloads/manua...BK-Install.pdf

    If he uses this, he can buy me a couple of half-decent bottles of red when he makes it home ... or not, as long as he gets home ok.

    Cheers, Paul.
    My toys, projects and write-ups at PaulP38a.com
    Reply With Quote Reply With Quote
« God bless EAS | EAS extended mode not working? »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!