Page 2 of 7 FirstFirst 1234 ... LastLast
Results 11 to 20 of 68

Thread: Cheap Gen 3's

  1. #11
    Join Date
    Apr 2012
    Location
    Engadine NSW
    Posts
    204
    Total Downloaded
    0
    Quote Originally Posted by Keithy P38 View Post
    I did post an extended bellow length in here at some stage. I think 380mm from memory for a rear gen III one.
    I found your post on that Keith and forwarded it on . Should get a response tomorrow.

    Also I could not find any bad feedback on them.

    Rob

  2. #12
    Join Date
    Apr 2012
    Location
    Engadine NSW
    Posts
    204
    Total Downloaded
    0
    They got back to me with a very vague answer. I have emailed a person who actually bought a set in Feb, waiting on a response but I'm not holding my breath.

    I'll give him a couple more days and I might take the plunge and buy a set since Arnotts just quoted me for a set of Gen 111's US$1016 delivered Bit hexy!!

    Just to digress slightly, my rear bags have a hand full of fine cracks on the roll, can any one tell me if this is considered bad at this point .

    Rob

  3. #13
    Join Date
    Feb 2010
    Location
    Townsville, QLD
    Posts
    2,581
    Total Downloaded
    0
    It's normal signs of wear with age.

    Getting close to bag retirement day!

  4. #14
    Join Date
    May 2013
    Location
    Cherrybrook, NSW
    Posts
    47
    Total Downloaded
    0
    Quote Originally Posted by Robsrod 58 View Post
    They got back to me with a very vague answer. I have emailed a person who actually bought a set in Feb, waiting on a response but I'm not holding my breath.

    I'll give him a couple more days and I might take the plunge and buy a set since Arnotts just quoted me for a set of Gen 111's US$1016 delivered Bit hexy!!

    Just to digress slightly, my rear bags have a hand full of fine cracks on the roll, can any one tell me if this is considered bad at this point .

    Rob
    Mine are looking the same so I'll be trying the ebay ones too before long.

  5. #15
    Join Date
    Jan 2012
    Location
    Bendigo
    Posts
    1,643
    Total Downloaded
    0
    I just recieved a quote of $255 shipping from arnott this morning, so it all adds up.
    Admittantly I drive until they start leaking, probably not the best thing; but they sometimes last a lot longer than you'd think.

    Rob I'm very interested in the answer they gave you; touring tech said their's are to gen3 spec(what every that is), and are replacement springs only and would only warrant them with OEM shocks. I also got told that they wouldn't give me any more lift or articulation... REALLY!

  6. #16
    Join Date
    Apr 2012
    Location
    Engadine NSW
    Posts
    204
    Total Downloaded
    0
    Quote Originally Posted by benji View Post
    I just recieved a quote of $255 shipping from arnott this morning, so it all adds up.
    Admittantly I drive until they start leaking, probably not the best thing; but they sometimes last a lot longer than you'd think.

    Rob I'm very interested in the answer they gave you; touring tech said their's are to gen3 spec(what every that is), and are replacement springs only and would only warrant them with OEM shocks. I also got told that they wouldn't give me any more lift or articulation... REALLY!
    Your right Benji at US$195.21, I was quoted for post your AU$255 spot on.

    You got more out of touring tech than I did. I wouldn't be surprised if they are the same bag from different vendors.

    This is the response I received from the seller--

    "Hello,
    Unfortunately I can't find out the full length of these air springs unless we install them on a vehicle. The only thing I can do is try to match them up with OEM part numbers or the VIN of your vehicle.

    Adan
    Buyautoparts
    1-858-200-0511
    " Gee thats helpful!!

    I,m not particular about extra lift as I mainly do touring and moderate off road. I'm looking for best value for $, I'm even considering a set of standard springs.

    Rob

  7. #17
    Join Date
    Jan 2012
    Location
    Bendigo
    Posts
    1,643
    Total Downloaded
    0
    Yeh not much to go on.

    Touring tech quality is good, but then standard bags last a while too. Depends on the spring rates you want.

  8. #18
    Join Date
    Apr 2012
    Location
    Engadine NSW
    Posts
    204
    Total Downloaded
    0
    Stuff it, I'll take the plunge and buy a set. If they were that bad the yanks would be blowing their tops and I see no evidence of that.......Stay tuned!!

    This thread ain't over yet!!

    Rob

  9. #19
    Join Date
    Apr 2012
    Location
    Engadine NSW
    Posts
    204
    Total Downloaded
    0
    Quote Originally Posted by Robsrod 58 View Post
    They got back to me with a very vague answer. I have emailed a person who actually bought a set in Feb, waiting on a response but I'm not holding my breath.

    I'll give him a couple more days and I might take the plunge and buy a set since Arnotts just quoted me for a set of Gen 111's US$1016 delivered Bit hexy!!

    Just to digress slightly, my rear bags have a hand full of fine cracks on the roll, can any one tell me if this is considered bad at this point .

    Rob
    For anybody interested in a set, I received a reply back from a buyer in the US

    "hey mate just saw your msg, they are great, really easy to install

    I got a price from landrover $2400 plus installation cost

    cheers Todd"


    Makes me feel better about my purchase!

    Rob

  10. #20
    Join Date
    Feb 2010
    Location
    Townsville, QLD
    Posts
    2,581
    Total Downloaded
    0
    We all know they are easy to install! Did he mention anything about the length?

Page 2 of 7 FirstFirst 1234 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!