Thread: Series 3 109 Sliders/sills

Well i got some more done today the pipes are all welded up & all pipe surports are welded on just need to give a little clean up on some of the welds. Will start to do the brackets tomorrow so if i'm lucky they should be all done hopefully by the end of the week if i'm lucky..( no picy's today).

OK got all the plate cut for the brackets today. A few more mesurements & drill some bolt hole a bit of welding & they will be ready for the paint.. no pics again but i will take some tomorrow if it doesn't rain & i can get everything out & started on all the above...

Well i got all rails & pipes done just need a little clean, just need to weld on the brackets..






Made the rear brackets & drilled the pilot holes, They just need a trim & holes inlarged. & weld the plate to the sliders which they bolt to..
Front ones are made just need to weld them on..






Hopefully all the welding & clean up will be done tomorrow then can start to paint them, 3 coats of black gloss rust gaurd..

OH & i got the grip tape cut..

Well just have to clean & trim the brackets for the rear.

Front brackets welded on just need clean..





Rear Brackets welded on.







Just need to cut the chassis brackets to shape drill out the holes & all done ready to paint...

looking good

noice job

Well got a bit done today all the brackets are trimed & cleaned..






All the holes are drilled in the brackets & on the brackets on the rails..





Just need to fit 4 captive nuts on each pair on top of the rails for the body brackets & then I can Paint them all & they will be finished..
Ordered all the bolts on friday so can pik them up tomorrow....