Thread: Arduino Modular Engine Sensors Unit (~$50)

I just finished moving from breadboard to 'veroboard' prototype stage. I found testing it in the car with a breadboard was too unreliable due to vibrations & movement, this fixes that. So i can now 'install' it & start using/testing it full time.

A couple more photo's, this time of the plug cables i made that go inline with for example the ECT sensor or Oil pressure switch, this way you are not cutting any loom wires. The plug type are standard fuel injector type plugs but the male variant was a little hard to find.

Originally Posted by haydent

does look impressive Mp3Car Custom Car Computers! would def be good if you need that much, i dont though.



prob a bit out of my scope at the moment sorry...

This site stocks some pretty good stepper motors.
Stepper Motor: Bipolar, 200 Steps/Rev, 20×30mm, 3.9V, 0.6 A/Phase | Australian Robotics

didnt even realise this was here, now to spend some time going though it.

Im just getting into arduino
do you have a project blog or anything? id love to do this and any other projects around

I don't but was thinking of creating something to put it all together. Glad to get some interest. The project has been delayed in testing since my last post as the zf reco'd transmission in it only lasted 11 months and the tc died . So it's been getting replaced under its warranty. ... In told zf don't even do their own tc's , contracting it to someone more specialized. ..

would be awesome if you could, i started putting one together but 17 pages was a little much.
If theres anything i can help with gimme a yell.

Ill send you a pm about it all mate

Makes sense though, we have a contractor to come in and do a lot of our mechanical work. Im able to do it but the risk is better off being with him.

Put 17 pages together for what?

I have a website I'll likely put it on. ..