https://www.aulro.com/afvb/images/im...017/05/308.jpghttps://www.aulro.com/afvb/images/im...017/05/309.jpghttps://www.aulro.com/afvb/images/im...017/05/310.jpghttps://www.aulro.com/afvb/images/im...017/05/311.jpg
Printable View
I've had a few weeks off from the ute, as work have had a big push for the end of financial year. 60 hrs a week in Victoria during winter doesn't leave much time left for hobbies.
Anyways back to it today.
Seats in
Lights
Grill
Work on the trayhttps://www.aulro.com/afvb/images/im...017/07/220.jpghttps://www.aulro.com/afvb/images/im...017/07/221.jpghttps://www.aulro.com/afvb/images/im...017/07/222.jpghttps://www.aulro.com/afvb/images/im...017/07/223.jpghttps://www.aulro.com/afvb/images/im...017/07/224.jpg
https://www.aulro.com/afvb/images/im...017/07/156.jpg
100x50
https://www.aulro.com/afvb/images/im...017/07/157.jpg
75x50
I'm going with the 75, it keeps the overall width down to 1780 where Land Rover recommends 1750 but this does not account for the wheel offset I'm using to accomodate 35"s. I will cover the tyres in plan view with two methods, one by clocking the tie down rails to sit wider than the box section and 25/40 mm of rubber.
https://www.aulro.com/afvb/images/im...017/07/155.jpg
One down the road for sale at a Toyota dealership
I'm looking at getting a main hoop made up from some 75 mm cds to follow the cab profile, plus 75 on the sides and plus 50 on the roof.
Anyone got any bender recommendations in Melbourne's East ?
Looks like 75 mm cds doesn't exist.
Ha, I thought I was wrong, but I was wrong.
3"OE x 0.083"wall
https://www.aulro.com/afvb/images/im...017/07/144.jpg
Just like being at home with the wife.
Today's mission should I choose to accept it.
Rails
https://www.aulro.com/afvb/images/im...2017/07/33.jpghttps://www.aulro.com/afvb/images/im...2017/07/34.jpg
I may raise up the aux tank 50mm