Thread: diff backlash

do you have a press?

here is my diff work it may be of some use to you
http://www.aulro.com/afvb/series-i-l...ration-33.html

Most of the backlash is probably from end play in the differential gears. This is very unlikely to give any problems. However, if there is any side or end play in the pinion or carrier bearings, then attention is needed. Pulling the diff out of the axle housing and checking the play is be pretty simple.

John

Originally Posted by rfurzer

I am starting to get stuck into my rebuild of an 86" with a series 2 2.25 engine.

It was bought as a basket case.

The diffs both have a lot of play - backlash. I can't seem to find much in the WSM (usefully says to pop them off to Rovers for a rebuild!).

How much is OK?

What is involved in tightening them up?

Russ

hi ring me regards rear diffs jim o428732001

Originally Posted by rfurzer

The diffs both have a lot of play - backlash. I can't seem to find much in the WSM (usefully says to pop them off to Rovers for a rebuild!).

You can't have a Rover manual then, because the procedure is very detailed in the genuine workshop manual. Available from most online Land Rover parts dealers,

Cheers Charlie