Swivel pins torque settings

**Veryan** · 16th October 2010, 09:58 PM

Hi All,

Anyone know that the torque wrench setting is for the nuts that hold the swivel pins in on a pendent steering arm set up?

Are they the same as the late SIIA/SIII with non - pendent types (50 - 65lb)?

Cant seem to find any mention of torque settings in the SII workshop manual.

So far I have about 100 thou of shims and I havent even got anywhere near that before it locks up.

All a parts are new, they are pressed in correctly and and sweep seal is not fitted.

James

**JDNSW** · 17th October 2010, 05:46 AM

Torque settings were virtually unheard of except for cylinder head bolts when the manual was written (and few owner/mechanics would have had access to a torque wrench) - use the same as the later figure.

You can expect to need more shims when new parts are installed, but note that it may be necessary to check that the shims are distributed between top and bottom so as to ensure that the swivel housing is aligned with the ball.

John

**Veryan** · 17th October 2010, 08:36 AM

Thanks John,

Will make sure that I put equal shims top and bottom.

James

Thread: Swivel pins torque settings

Thread Tools

Swivel pins torque settings

Bookmarks

Bookmarks

Posting Permissions