Thread: Hard brake pedal on 2a

Thanks guys,
Will get a new set today and try fitting over the weekend.
There's been a lot of new fluid pumped through the system due to various lines and cylinders being replaced. Theres a couple of hard brake lines to finish off still. Being stored at a beachside town for many years (before i bought it) means the lines are quite brittle and rusty.
I am going to give the landy a proper stripdown and rebuild once I get a couple of other non land rover projects out of the way !

Thanks again.

Peter

Originally Posted by the big fist

Theres a couple of hard brake lines to finish off still. Being stored at a beachside town for many years (before i bought it) means the lines are quite brittle and rusty.

I suspected as much after looking at your avatar

Don't trust rusty pipes, even if it appears to only to be surface rust. One leak on a single circuit brake system and death-stalks!

I know what you mean about the difficult ones; on my S3 I re-routed the front two to sit on top of the chassis rails and the LH one runs around behind the engine,

Cheers Charlie