Results 1 to 4 of 4

Thread: How do you....

  1. 1st May 2011, 03:55 PM #1
    drifter Guest

    How do you....

    ... hold the grill badge on?

    Mine would appear to be screwed on with something akin to a self-tapping screw. There are two clips in the radiator support that seem to be there for it.

    Will they not vibrate out?


    Thanks in advance...
    Reply With Quote Reply With Quote
  2. 1st May 2011, 04:44 PM #2
    Johnno1969's Avatar
    Johnno1969
    Johnno1969 is offline Wizard Supporter
    Join Date
    Dec 2009
    Location
    Queensland (though occasionally elsewhere)
    Posts
    1,431
    Total Downloaded
    0
    Nope, they should be fine and stay where you put 'em.

    John
    Reply With Quote Reply With Quote
  3. 1st May 2011, 04:51 PM #3
    JDNSW's Avatar
    JDNSW
    JDNSW is offline RoverLord Silver Subscriber
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,510
    Total Downloaded
    0
    Nope -as Johnno says, they will stay put if they have the original clips. Because these are spring loaded against the stem of the screw, they act as an anti-shake device.

    I have seen them replaced by a captive nut, and these do tend to rattle loose.

    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol
    Reply With Quote Reply With Quote
  4. 1st May 2011, 05:37 PM #4
    drifter Guest
    Thanks guys.

    They look like original clips. They are not the original screws. I don't have them but I do have some long black self-tappers.

    I was just a bit concerned because I can't do them up too tight or they will bend the emblem plate.
    Reply With Quote Reply With Quote
« A Shocking Question | Seats »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!