Page 9 of 10 FirstFirst ... 78910 LastLast
Results 81 to 90 of 95

Thread: The Grey Ghost - a Rolling Restoration

  1. #81
    Join Date
    Mar 2010
    Location
    South Africa
    Posts
    867
    Total Downloaded
    0
    It's a BEAUT, I reckon you got it just right.

  2. #82
    Join Date
    Apr 2002
    Location
    Godwin Beach 4511
    Posts
    20,770
    Total Downloaded
    32.43 MB
    very nice bit of kit...

    you have done well!
    2007 Discovery 3 SE7 TDV6 2.7
    2012 SZ Territory TX 2.7 TDCi

    "Make the lie big, make it simple, keep saying it, and eventually they will believe it." -- a warning from Adolf Hitler
    "If you don't have a sense of humour, you probably don't have any sense at all!" -- a wise observation by someone else
    'If everyone colludes in believing that war is the norm, nobody will recognize the imperative of peace." -- Anne Deveson
    “What you leave behind is not what is engraved in stone monuments, but what is woven into the lives of others.” - Pericles
    "We can ignore reality, but we cannot ignore the consequences of ignoring reality.” – Ayn Rand
    "The happiness of your life depends upon the quality of your thoughts." Marcus Aurelius

  3. #83
    Join Date
    Sep 2010
    Location
    Qld
    Posts
    806
    Total Downloaded
    0
    Fantastic work Tom. Finally all the effort, hard work, blood sweat and tears and parts sourcing expeditions have paid off.

    I like the look and nice to see some of my donor car's parts breathing new life into the old girl.

    So when will we expect to see a start on the next project? Love the mini too, used to have a moke years ago, there is something about them.....wish I could still fit into one comfortably but at 6'2" it is a bit hard.

  4. #84
    Join Date
    Apr 2011
    Location
    Wandong,Victoria,Australia
    Posts
    3,412
    Total Downloaded
    0

    Maiden Run...

    Hi All,

    Finally got the number plates from Vic-Roads, installed and took the Grey Ghost for a test run...

    The car has a bog standard 2.25 petrol engine. It has had a full service - all oils/filters replaced.

    Unfortunately not without some issues....

    When going up a steep hill (bitumen road, not massively steep - I normally go up this hill in 2nd gear in 1976 Mini) - the Ghost, coughs and splutters like he isn't getting enough fuel. The car kangaroo hops and then eventually stops. It doesn't stall - you put it back into 1st, give it some revs - and take off again, like nothing happened... Suggestions?

    After completing the test drive (not far - maybe 10kms) I drove home and parked. When I touched the front and rear wheels - he actual wheel face, the area around the wheel nuts - the steel is warm to the touch. Is this normal?

    Here are some photo's:




    Regards,
    The Grey Ghost...

  5. #85
    Join Date
    Jan 1970
    Location
    under a rock, next to a tree, at Broadmarsh
    Posts
    6,738
    Total Downloaded
    0

    fine tuning a fine machine

    Quote Originally Posted by grey_ghost View Post
    The car has a bog standard 2.25 petrol engine. It has had a full service - all oils/filters replaced.
    When going up a steep hill (bitumen road, not massively steep - I normally go up this hill in 2nd gear in 1976 Mini) - the Ghost, coughs and splutters like he isn't getting enough fuel. The car kangaroo hops and then eventually stops. It doesn't stall - you put it back into 1st, give it some revs - and take off again, like nothing happened... Suggestions?
    That does sound like from your description that the motor is starving for fuel,
    how is the gauze filter on the tank pickup?

    After completing the test drive (not far - maybe 10kms) I drove home and parked. When I touched the front and rear wheels - he actual wheel face, the area around the wheel nuts - the steel is warm to the touch. Is this normal?
    When I have adjusted the brakes or the wheel bearings, I do the same check for heat at the hubs after a run.

    cold; means it has settled down and all is good.
    warm; maybe a high spot on the brakes or the new bearings are a still a bit tight, check it again sometime but leave alone.
    hot; and maybe only on one wheel, probably wants looking at as something needs it's adjustment letting off a bit as it is too tight.
    Too hot to touch; not good, there is something needs to be fixed straight away before you go on again.
    Burning the paint off; get someone else to do the work and hand your mechanics ticket in.
    Last edited by wrinklearthur; 5th October 2012 at 09:41 AM. Reason: at e

  6. #86
    Join Date
    Jan 1970
    Location
    Central West NSW
    Posts
    29,668
    Total Downloaded
    0
    Engine problem sounds as if it is fuel - likely causes, as suggested, the strainer on the pickup in the tank, or the strainer on the pump, or an air leak anywhere between the pump and the tank - usually, but not always, shows up as a slight fuel leak, but could be a tiny rust hole in the pickup inside the tank. But I have had similar symptoms that turned out to be the points closed up, and could also be any ignition problem such as HT leads - spark is good enough except when engine is asked to work hard with more mixture and higher compression pressures.

    Back wheels - warm to touch, no great worry, but if you can't keep your hand firmly on it, needs investigation. Most likely dragging brakes - jack up the wheel should turn freely (out of gear and handbrake off) - apply and release brake, should still turn freely. Don't forget to chock front wheels before jacking up a back wheel.

    John
    John

    JDNSW
    1986 110 County 3.9 diesel
    1970 2a 109 2.25 petrol

  7. #87
    Join Date
    Apr 2011
    Location
    Wandong,Victoria,Australia
    Posts
    3,412
    Total Downloaded
    0

    Small Update

    Hi All,

    I decided to give the Grey Ghost a minor present.

    I installed a leather steering wheel cover - man that was a job! It took about 2 hours but I am happy with the result, and won't get black/sticky hands in winter anymore!

    88 Perentie FFR - Club Rego
    93 Discovery 1 200 Tdi - Club Rego
    03 130 Td5 Single Cab
    06 Discovery 3 Petrol
    22 Defender 90 - Full rego

  8. #88
    Lostkiwi Guest
    Looks good
    Where did you pick that up from TB?

  9. #89
    Join Date
    Apr 2011
    Location
    Wandong,Victoria,Australia
    Posts
    3,412
    Total Downloaded
    0
    Hi Lost,

    I got it from the usual suspect - fleabay!

    Here is the link -

    FOR LAND ROVER 2 SERIES TOP QUALITY ITALIAN LEATHER STEERING WHEEL COVER BLACK | eBay

    Cheers,
    The Grey Ghost
    88 Perentie FFR - Club Rego
    93 Discovery 1 200 Tdi - Club Rego
    03 130 Td5 Single Cab
    06 Discovery 3 Petrol
    22 Defender 90 - Full rego

  10. #90
    Join Date
    Apr 2011
    Location
    Wandong,Victoria,Australia
    Posts
    3,412
    Total Downloaded
    0
    Hi All,

    A few weeks ago I took the Grey Ghost for a drive, and noticed that the water pump had expired..

    So off with the pump and a reconditioned one has been installed. (I have the "rare" 8 bolt water pump, which is a bummer as both of my Series II are in the same boat)

    Took the car for a spin - everything went well, until I noticed this a few hours later:


    I have changed it for a spare, and will get it looked at next weekend!
    88 Perentie FFR - Club Rego
    93 Discovery 1 200 Tdi - Club Rego
    03 130 Td5 Single Cab
    06 Discovery 3 Petrol
    22 Defender 90 - Full rego

Page 9 of 10 FirstFirst ... 78910 LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!