Thread: Series Brake Bleeding

Thanks everyone for the info, I discovered that the rear right slave cylinder is leaking fluid cause there's brake fluid all over the wheel after I've pumped the brakes and I can't get any pedal no matter how much I pump, so I'm going to fix that and try these tips out and let everyone know how it goes.

I was having trouble bleeding my brakes on my series 2. All appeared ok but pedal nearly went to floor ....
I read somewhere that the fix is to turn all snails cams until wheels locked and then bleed brakes again, then back snails off 1-2 notches on each wheel.
I did as suggested and brakes where much better immediately !!!!

I have brakes! Finally I get brakes on the first pump which is good enough for me, on the second pump it locks the rears and pulls to the left so I just have to remember that and hold on to the wheel to stop the rear overtaking the front I used a combination of pumping the pedal really hard and fast and also trying to open the bleed nipple really fast to get the fluid to shoot out fast instead of just dribble. Thanks everyone for the advice.

Seeing it's a paddock car, why not use a vice grip to isolate the leaky cylinder?

If the locking rears is the worst problem, why not isolate them by clamping the rear rubber hose? The rears contribute SFA to the braking anyway!

My Series 3 was giving me a hard time bleeding the brakes after a complete retube. After trying pressurising the master cylinder with a bottle and pump and getting soaked with brake fluid, as a last resort got T and S to help. Still no good, so got a balloon from Coles ($1 a packet of ten) cut the end off and stretched it over the reservoir. Wrapped some electrical tape around it and filled the thing with a syringe thingee from Supercheap. Blew into the balloon and clipped it off with one of those bag clips from the kitchen. Then went round the wheels opening the nipple with a clear pipe on the end to see the bubbles. Daft as it sounds it worked ! I could do two wheels before filling the tank and blowing up the balloon again so it only took a few minutes to do, apart from jacking up one end at the time. Total cost 10 cents for one ballloon. I have a single system with a CV master cylinder so it may not have enough pressure to do dual system.

Originally Posted by geodon

Seeing it's a paddock car, why not use a vice grip to isolate the leaky cylinder?

If the locking rears is the worst problem, why not isolate them by clamping the rear rubber hose? The rears contribute SFA to the braking anyway!

Locking rears isn't the worst problem really, it's worse to have no brakes. I tried to vise grip trick before on the fronts and it work until the front brake lines split from having the vise grips and having just the rears lock on wet grass was suicidal.

Angus1- As for jacking up each wheel I've found a far quicker and easier way of getting one end of the vehicle of the ground, I use a John Deere front end loader, unfortunately not everyone has one but they do a great job of lifting one end at a time.

I like the idea of a John Deere tractor but the wife wouldn't agree. I'd probably do all the gardening with it! Fixed the gearbox gate on one in the States then had fun shovelling horse s**t about the yard, great fun. Found a bobcat handy for changing the engine of my Kombi useful too, but then i am a lazy bugger. I'll have to try the bleeding trick on my D1 when I get time, struggling with the idea of replacing the headlining at the moment.

I have the CB type cylinder, I got an my fluid tin lid and drilled and mounted a 1/4 male flare adapter through the lid, put a 1/4" tail off the top and connected an air hose from the compressor to it. The booster was blocked internally so I had to bypass that temporarily and pressure bled the whole system fairly quickly until the passenger flexible hose (I clamped off earlier) split in two . replaced that and bled it again, all good until I can time to re build the booster.