Thread: Series 2A door top alignment...HELP!!!!

If the gap is sideways - i.e. towards and away from the body, the alignment technique is the bend the bolts that attach the door top to the bottom. If the problem is vertical, it means either the door hinges need adjusting - there is some movement in the bulkhead hinge attachments - or there is a problem with body alignment, possibly due to accident damage or poor assembly.

John

There is a rubber seal that goes between door bottom and top, it would only add a mm or two though. Are they fitted to yours?
Mine only has one intact and the side without it doesn't suffer from the absence.
-Mark

As JD says, bend the bolts to move the door top closer to the body. The alternative is to make up a couple of packing pieces about 40mm long and 5-10mm wide, and fit them in the outer side of the join. 3mm thick aluminium works well.

Originally Posted by longing4alandy

There is a rubber seal that goes between door bottom and top, it would only add a mm or two though. Are they fitted to yours?
Mine only has one intact and the side without it doesn't suffer from the absence.
-Mark

Hi John,
I fitted new rubbers between the tops and bottoms, the drivers side is perfect, just the passenger side.
I will try to bend the bolts but the door tops are brand new, I should not have to!!
Paul.

Originally Posted by isuzurover

As JD says, bend the bolts to move the door top closer to the body. The alternative is to make up a couple of packing pieces about 40mm long and 5-10mm wide, and fit them in the outer side of the join. 3mm thick aluminium works well.

Thanks Ben,
I will give it a go and keep you posted.
Thank you to all for your suggestions, I appreciate the input.
Paul.

Originally Posted by landylunatic

I will try to bend the bolts but the door tops are brand new, I should not have to!!

Being new is precisely why you have to bend the mounting bolts.

Aaron.