Thread: MEET Harry Highback

Did you get a new welder, Jason?????

Originally Posted by Ausfree

Did you get a new welder, Jason?????

Na Aus they quoted me a minim of $300 for the repairs. Plus parts. I found the part I need on eBay for $49 free postage. It's the exact same part. It's the feed for the wire on my mig. So I'll get that in the next couple of weeks. Had a few big bills & a $1200 vet bill. From the pregnant dog. She need an emergency C section as they was to big to push out. Had 3 but only one survived. Plus Centrelink have stuffed our payments up now that Cody is 18 & finished school. So once back on our feet I'll get the part. Plus I'm looking at a 40amp plasma cutter since I cut so much metal.

Ok so I did a bit more to the disco over the last couple of days . Ive cut all the big body mounts off..

I took the series 3 bulkhead outriggers & made them so they fitted disco.& tack welded them on the chassis inplace..

I then started to fit the lower half of the truck cab. So I can make the brackets for the rear bulkhead..

Well the disco radiator is going to be way to big. Its about an inch & a half to wide on each side . Id have to cut up the gaurds to much to use it..








So does anyone know where I can get a cheap stage one radiator or do you have one you could sell me. ??

That's a very impressive start.

Can't help with finding a Stage 1 radiator, but would something like a Rover SD1 fit?

Originally Posted by disco2hse

That's a very impressive start.

Can't help with finding a Stage 1 radiator, but would something like a Rover SD1 fit?

I've never seen one out of a SD1 so I have no idea realy. Something to look at though.