Reply With QuoteWhat configuration do you have? Ie; engine/ gearbox type/ witch vehicle model? I have a few cars in the driveway so hopefully 1 might match up.
Cheers
David
Sent from my GT-I9300 using AULRO mobile app
Hi. I've decided to install a removable crossmember for the gearbox. I got all excited and charged ahead with cutting out the old one, without taking any measurements off it. Woops.
I noticed when i re-hung the box casing on the bellhousing that it wasn't quite centered between the chassis rails. I'm hoping someone can tell me if it should be, or if not, some rough measurements for the gearbox mounts to the rails? I'll be sitting the seatbox and gearbox tunnel back in to check the levers all line up, but some conformation numbers would be nice
Fossicker
What configuration do you have? Ie; engine/ gearbox type/ witch vehicle model? I have a few cars in the driveway so hopefully 1 might match up.
Cheers
David
Sent from my GT-I9300 using AULRO mobile app
Its a series 3, 2.25 petrol, and the gearbox is a suffix 'A'
Cheers
Lord Jock
I have the seatbox out of my 2A at the moment, so I can get the measurement for you.
From the side of the hand brake drum it is exactly 300mm to the chassis on the left side.
Also on the left side it is 172mm (6 3/4") from the flat area where the gear box filler plug is to the chassis.
I used a telescopic gauge to measure these so any error would be minimal.
Cheers, Mick.
Last edited by mick88; 18th July 2016 at 10:59 AM. Reason: Update
1974 S3 88 Holden 186.
1971 S2A 88
1971 S2A 109 6 cyl. tray back.
1964 S2A 88 "Starfire Four" engine!
1972 S3 88 x 2
1959 S2 88 ARN 111-014
1959 S2 88 ARN 111-556
1988 Perentie 110 FFR ARN 48-728 steering now KLR PAS!
REMLR 88
1969 BSA Bantam B175
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks