Thread: Rebuilding a 4cyl

Does anyone know the weight of a complete 2.25P?

What about just the assembled motor? ie without carby, inlet & exhaust manifolds, starter, alternator & dizzy?

Thanks

Doug

Originally Posted by Tank

If you buy that set from the UK you will need to remove the rings from the pistons (they state pistons with rings fitted) and check their gap clearance in each corresponding bore, don't trust that the rings are already gapped from factory, each and every compression ring must be checked in it's bore before fitting to that bore's piston, number your pistons with texta so you dont mix them up, Regards Frank.

Yep, if i end up getting that kit i will definitely be checking everything is to size before it goes in.

Cheers
Paul