Results 1 to 5 of 5

Thread: ACE accelerometer sensor

  1. 19th April 2010, 06:32 PM #1
    tapout
    tapout is offline Master
    Join Date
    Mar 2010
    Location
    gold coast
    Posts
    131
    Total Downloaded
    0

    ACE accelerometer sensor

    On the weekend i put a pair of rock sliders on my car, the right hand side mount was in the way of the accelerometer sensor so i cut and moved the mount down a couple of inches, job done but now the ace light comes on (amber) and wont go out, fluid is good, no leaks, if i push the plug in real hard and restart the car the light sometimes goes out but then comes back on later. What can i do to fix the prob, car is a 2000 D2 manual v8 ace, no other warning lights.

    Thanks,
    Jason.
    Reply With Quote Reply With Quote
  2. 19th April 2010, 07:50 PM #2
    Graeme
    Graeme is online now Swaggie Vendor
    Join Date
    Jan 1970
    Location
    NSW SW Slopes
    Posts
    12,037
    Total Downloaded
    0
    I'd suspect the accelerometer plug is not seating properly due to dirt or rubbish or the seal has been dislodged. You might have to remove the accelerometer to see inside the plug properly.
    MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
    VK2HFG and APRS W1 digi, RTK base station using LoRa
    Reply With Quote Reply With Quote
  3. 20th April 2010, 06:15 AM #3
    discowhite's Avatar
    discowhite
    discowhite is offline TopicToaster
    Join Date
    Jan 1970
    Location
    Padstow NSW
    Posts
    4,501
    Total Downloaded
    0
    Quote Originally Posted by Graeme View Post
    I'd suspect the accelerometer plug is not seating properly due to dirt or rubbish or the seal has been dislodged. You might have to remove the accelerometer to see inside the plug properly.

    or reset the calibration of that accelerometer with nanocom.
    Reply With Quote Reply With Quote
  4. 21st April 2010, 05:58 PM #4
    tapout
    tapout is offline Master
    Join Date
    Mar 2010
    Location
    gold coast
    Posts
    131
    Total Downloaded
    0
    Where abouts in the nanocom would i find that function?

    Thanks,
    Jason.
    Reply With Quote Reply With Quote
  5. 22nd April 2010, 05:54 AM #5
    discowhite's Avatar
    discowhite
    discowhite is offline TopicToaster
    Join Date
    Jan 1970
    Location
    Padstow NSW
    Posts
    4,501
    Total Downloaded
    0
    in the back left hand corner of the printed circut board theres a resistor... south east of that is a micro chip, ide say its in there somewhere















    or you could try looking in the disco ACE section or the valeo BCU section.
    i know ive seen the calibration section but cant remember where.
    Reply With Quote Reply With Quote
« Whining from fuel pump | Battery Charging »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!