Results 1 to 4 of 4

Thread: Diff torque settings needed

  1. 5th July 2010, 04:47 PM #1
    Hall's Avatar
    Hall
    Hall is offline Wizard Subscriber
    Join Date
    Oct 2009
    Location
    Cranbourne North
    Posts
    1,929
    Total Downloaded
    0

    Diff torque settings needed

    Hello all.
    Have tried the search function but have had no joy.I will most likely be told that there is a file or some thing that I should have known about.What I`m after is torque settings for the diff pinion nut and the bolts that hold the carrier bearing caps on.
    Cheers Hall
    Reply With Quote Reply With Quote
  2. 5th July 2010, 08:53 PM #2
    400HPONGAS's Avatar
    400HPONGAS
    400HPONGAS is offline Master
    Join Date
    Jan 2010
    Location
    Newman WA
    Posts
    889
    Total Downloaded
    0
    90 nm for the carrier bearings and 130 NM for the Pinion nut . but thats final torque after you have set the pinion height and the backlash . You are setting the Pinion height and rotating torque first arent you ? Well thats for a RRC diff
    Try searching any of the RAVE CD's or a workshop manual . but most of all if you dont know what you doing then find somebody that does !!!!
    Reply With Quote Reply With Quote
  3. 5th July 2010, 09:26 PM #3
    Hall's Avatar
    Hall
    Hall is offline Wizard Subscriber
    Join Date
    Oct 2009
    Location
    Cranbourne North
    Posts
    1,929
    Total Downloaded
    0
    Yep know about setting the pinion height and the rotating torque,also the back lash,checking the crown wheel run out etc and bluing the teeth to check the final contact pattern to see if the pinion height is correct with the right back lash.Have had to set up a few diff`s .Is my first rangie diff though.
    Cheers Hall
    Reply With Quote Reply With Quote
  4. 5th July 2010, 09:36 PM #4
    400HPONGAS's Avatar
    400HPONGAS
    400HPONGAS is offline Master
    Join Date
    Jan 2010
    Location
    Newman WA
    Posts
    889
    Total Downloaded
    0
    And were those Diffs ,Crush piece type or Shim type ? Strange how you knew the rotating torque , the backlash settings and the contact patterns but didnt know the Final torque settings !!! Suggest you buy a book on the Rover diffs !!
    Reply With Quote Reply With Quote
« Tyre levers - what size? | Replacing shocks.. help needed urgent! »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!