Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: vnt turbo dismantle

  1. 23rd July 2010, 10:38 PM #11
    steveG's Avatar
    steveG
    steveG is offline TopicToaster Subscriber
    Join Date
    Sep 2008
    Location
    Geelong, VIC
    Posts
    4,442
    Total Downloaded
    0
    There are plenty of tutorials on the 'net on how to put an overhaul kit in a normal T25 etc, but would be great if you could post up any differences for a VNT, and especially any gotcha's that you find along the way.

    Steve
    Reply With Quote Reply With Quote
  2. 23rd July 2010, 10:46 PM #12
    Vern's Avatar
    Vern
    Vern is offline OldBushie
    Join Date
    May 2006
    Location
    Woolgoolga
    Posts
    7,870
    Total Downloaded
    0
    Can do, will sit down with rovercare one arvo and tinker with it and take some pics
    ITs basically the same as a t25 in regaurds to putting a kit in it, I have 2 to rebuild so if i stuff the first one, should be able to get the other right
    Reply With Quote Reply With Quote
  3. 24th July 2010, 08:38 AM #13
    Dougal
    Dougal is offline ForumSage
    Join Date
    Sep 2007
    Location
    Kiwiland
    Posts
    7,246
    Total Downloaded
    0
    The old T25's etc ran individual journal bearings one at each end of the shaft. These GT series turbos run a single sleeve bearing which spans through the middle of the housing.

    All works in the same way, but you won't have to go digging in the turbine end to release the bearing in there.
    Reply With Quote Reply With Quote
Page 2 of 2 FirstFirst 12
« Heater repairs | td5 with no power »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!