Results 1 to 4 of 4

Thread: Perentie Spare Wheel Mount

  1. 20th August 2010, 03:20 PM #1
    TonyC
    TonyC is offline Wizard Silver Subscriber
    Join Date
    Sep 2007
    Location
    NE Victoria
    Posts
    1,414
    Total Downloaded
    32.83 MB

    Perentie Spare Wheel Mount

    Can any one tell me how the rear of a Perentie chassis is set up to accommodate the spare wheel?

    I assume the rails flare out behind the spring mounts, but do they then run parallel again where they join the rear cross member?

    How is the spare lifted and held?

    On my 130 (I assume rear axle to rear cross member is the same as a 110) there doesn't seem to be enough room between the diff and the rear cross member to fit in the spare, is the Perentie longer in the rear overhang?

    Thanks

    Tony
    Reply With Quote Reply With Quote
  2. 21st August 2010, 06:10 AM #2
    rar110's Avatar
    rar110
    rar110 is offline ForumSage Subscriber
    Join Date
    Jan 1970
    Location
    Brisbane, Queensland
    Posts
    5,778
    Total Downloaded
    0
    I have a perentie rear end in the backyard. The chassis rails are wider behind the springs and cross member sits further back. All is heavier duty so vehicle can be airlifted. PM me your email and will send you a pic. In the middle is a wheel winch (fairly common part), with a shaft going to the side of the vehicle with a wheel nut at the end of the shaft. You the use the wheel brace to winch up/down the spare.

    This set up would probably suit a 130 as you could fit a fuel tank before the rear axle. However I don't know if it could be engineered/approved.
    L322 tdv8 poverty pack - wow
    Perentie 110 wagon ARN 49-107 (probably selling) turbo, p/steer, RFSV front axle/trutrack, HF, gullwing windows, double jerrys etc.
    Perentie 110 wagon ARN 48-699 another project
    Track Trailer ARN 200-117
    REMLR # 137
    Reply With Quote Reply With Quote
  3. 21st August 2010, 11:20 AM #3
    TonyC
    TonyC is offline Wizard Silver Subscriber
    Join Date
    Sep 2007
    Location
    NE Victoria
    Posts
    1,414
    Total Downloaded
    32.83 MB
    Thanks rar110,
    I can't see any reason why getting it engineered would be a problem if done properly.

    PM sent

    Thanks

    Tony
    Reply With Quote Reply With Quote
  4. 21st August 2010, 06:36 PM #4
    lokka Guest
    My new county which is now a 130 county has the spare up under the tray verry similar to the army set up the rear of the chasis has been widened and the original X member reused and it has a winch set up at the top to lift the wheel up inside the rear .

    Tomoro i will be taking pics of the whole truck and starting a thread in members rides when i do this prob later tomoro night i will link a pic of the rear in this thread .
    Reply With Quote Reply With Quote
« stuck on the side of the road ,Defender 300tdi | TC and hill descents »

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!