Thread: Rear main seal

I have had a look at old posts but cant find the answer Im looking for

Can the rear main seal be done with out removing anything else or is it easier to remove the sump etc

Is there a manual that shows where all the correct gaskets go on a LT95 (I need to replace the pump gasket plus more)

Last but not least does anyone have know what the alignment measurements are for a 110 (body)

Cheers

Adam

Originally Posted by agrojnr

I have had a look at old posts but cant find the answer Im looking for

Can the rear main seal be done with out removing anything else or is it easier to remove the sump etc

Is there a manual that shows where all the correct gaskets go on a LT95 (I need to replace the pump gasket plus more)

Last but not least does anyone have know what the alignment measurements are for a 110 (body)

Cheers

Adam

The RRC CD from the shop here has the LT95 parts breakdown in it.

Apart from the oil pump cover gasket, you could have a leaking input shaft seal as there is a drain hole in the housing that allows any oil that leaks past the seal to drip down over the oil pump cover.
I've just done as djam1 suggests and lapped my oil pump cover. It was definitely warped, and took me about an hour as I only had 320grit wet/dry on hand.

Steve