Reply With QuoteFrom memory I think it is about 50mm, but cannot give an accurate figure until I get home on Friday. Maybe someone else will be able to give the correct figure before then.
TopicToaster
SubscriberAnyone know that actual length difference between Stage1 and RRC/110 front output housing on a LT95.
I know the Stage1 housing is longer - just trying to work out how much its contributing to the rear uni-joint binding on my front propshaft (in a County 110).
Alternatively, could someone measure a RRC/110 housing and let me know the dimension so I can compare?
Steve
TopicToaster
From memory I think it is about 50mm, but cannot give an accurate figure until I get home on Friday. Maybe someone else will be able to give the correct figure before then.
Cheers......Brian
1985 110 V8 County
1998 110 Perentie GS Cargo 6X6 ARN 202516 (Brutus)
TopicToaster
Steve, The 110/RR housing is 95mm and the Stage 1 is 125mm, so 30mm is the difference.
Cheers......Brian
1985 110 V8 County
1998 110 Perentie GS Cargo 6X6 ARN 202516 (Brutus)
TopicToaster
SubscriberThanks Brian.
Now I just have to get my maths hat on and work out how much suspension travel that equates to
With "deburring" the edges of yoke its now rotating freely at full droop with standard shocks. Another couple of inches without binding would be nice so I could get the standard range (extended bump stops for the Isuzu takes a bit away).
If the shorter housing wont do it then I guess its different shaft/yokes to give greater than the standard 20deg yoke angle.
Steve
Posting Permissions
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks