Results 1 to 4 of 4

Thread: Which Head Gasket 300TDI

  1. #1
    lokka Guest

    Which Head Gasket 300TDI

    Im about to buy a new turner head from the UK and need to know which head gasket i need to use as i dont have the head off as yet and am unsure as to what one i need 1,2,3 or no hole being the thickest with no hole maby best to run with it ?

    Any help would be good thanks

  2. #2
    Join Date
    Sep 2008
    Location
    Geelong, VIC
    Posts
    4,442
    Total Downloaded
    0
    AFAIK there should be a bit of the gasket hanging out the side of the engine just above the the lift pump where you can see the holes.
    Thankfully never had to do one on my 300tdi, but recall seeing the piccy in Rave.

    Steve

  3. #3
    Join Date
    Jan 1970
    Location
    Nanny state UK...
    Posts
    3,253
    Total Downloaded
    0
    If you look at your existing head gasket, there will be a tab which sticks out from between the head & block (sorry, can't remember which side of the engine). It is only about an inch long but it will have the holes punched in it, so that it is clearly visible while fitted.

    HTH

    M

  4. #4
    Join Date
    Apr 2009
    Location
    South Sydney
    Posts
    2,499
    Total Downloaded
    0
    Just been through this, on the drivers side of the motor, there is a tab of head gasket that stick out, IIRC it is between the 2 & 3 cylinder fuel injector lines. May be slightly further back. if it hasn't had a head gasket, technically head surfaced (don't quote me on this not 100%) there should be no holes.

    Cheers
    Will

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!